User manual KRESS 900 WTSE

[. . . ] Pay attention to the direction of rotation: Always hold the machine such that the grinding dust or sparks fly away from the body. Be careful if persons or objects are standing nearby. Inflammable material must not be kept in the vicinity. Check the working area with a metal detector in order to avoid damaging any concealed electrical leads, or water and gas pipes. [. . . ] assembling the auxiliary handle Place the clamping strap around the gearhead and insert it in the openings on the clamping part of the auxiliary handle. The auxiliary handle is locked by turning it clockwise. The auxiliary handle can be turned to the required position. By turning the auxiliary handle clockwise, it is locked again. Use the mains cable module provided only for Kress Electro-Tools. Do not attempt to operate other machines with the module. Only use original Kress mains cable modules and at least flexible rubber tube (code designation H05 RR-F). English Putting into Operation Check before putting into operation that the mains voltage agrees with the voltage specified on the nameplate of the machine. Before any work on the machine itself, pull the mains plug!For disassembling the protective guard 5, remove the 2 screws and take off the counterflange. To lock, push the On/Off switch 1 forwards fully. By pressing the projecting front edge of the On/Off switch 1, it returns to its initial position. Before any work on the machine itself, pull the mains plug!Only cut and grind when the protective guard is mounted!It must be possible to move the grinding tools slightly, but they should not sit too loosely on the spindle. The starting current limiter reduces the starting current. The motor slowly runs up to no-load speed, thereby protecting the user and the gearing and prolonging the life of the machine. Full power is then available and the machine turns at the maximum possible speed. When the load is reduced, the voltage drops again and the sound level for the user is reduced. The quick-lock nut 8 can be loosened and unscrewed quickly without additional tools. If the quick-lock nut can not be loosened by hand, use only a two-pin spanner to loosen it. If the grip pulley is damaged or does not hold down, the quick-lock nut must not be used further under any circumstances. [. . . ] We reserve the right to repair defective parts or replace them with new parts. Improper use or handling as well as opening of the machine by unauthorised repair agencies voids the guarantee. Parts subject to wear are excluded from the guarantee. The guarantee may only be enforced when defects are reported without undue delay (including shipping damage). [. . . ]