User manual KRESS AB 120

[. . . ] Continuous operation under strong load and low speed can overheat the motor. Allow the motor to cool down in no-load when set at a high speed. Our equipment is designed in accordance with European regulations (EN standards) for the utmost safety of the user. Machines with double insulation always carry the international . [. . . ] The machines are interference-suppressed in accordance with EN 55 014. The fully automatic spindle locking makes possible quick and easy changing of the tool in the drill chuck. For soft drill shafts, it may be necessary to retighten after a short time!However, should you operate the machine on a continuous basis over long periods of time we recommend that you send us the machine for thorough cleaning and an inspection. This will spare you unnecess-ary repair expenses and increase the machine's service life. If you always clean the ventilator of dust after each operation, the motor will enjoy an ever longer service life. Remove the left-hand threaded screw that secures the drill chuck on the drill spindle against unscrewing in left rotation. The drill chuck can then be loosened by lightly striking a Allen key clamped in the drill chuck and screwed off. remounting takes place in the reverse order. Clean the flat surfaces on the drill chuck and spindle before mounting. The A-weighted noise level of the machine is typically: Sound pressure level (LpA) 77 dB(A) Sound power level (LwA) 88 dB(A) Measurement uncertainty K = 3 dB The noise level can exceed 85 dB(A) during operation. 5 m/s2 The vibration emission level given in this information sheet has been measured in accordance with a standardised test given in EN 60745 and may be used to compare one tool with another. The vibration emission level will vary because of the ways in which a power tool can be used and may increase above the level given in this information sheet. This could lead to underestimation of vibration when the tool is used regularly in such a manner. Note: To be accurate, an estimation of the level of exposure to vibration experienced during a given period of work should also take into account the times when the tool is switched off and when it is running but not actually when doing the job. This may significantly reduce the exposure level over the total working period. Do not dispose of electric tools together with household waste material!Recycle raw materials instead of disposing as waste The machine, accessories and packaging should be sorted for environmental-friendly recycling. These instructions are printed on recycled paper manufactured without chlorine. the plastic components are labelled for categorised recycling. [. . . ] These instructions are printed on recycled paper manufactured without chlorine. the plastic components are labelled for categorised recycling. Subject to change without notice Avant de mettre la machine en marche, il convient de lire entièrement la notice d'utilisation et d'observer les consignes de sécurité données dans cette notice ainsi que les consignes de sécurité générales relatives aux outils électriques précisées dans la brochure ci-jointe. CE Declaration of conformity We declare under our sole responsibility that this product is in conformity with the following standards or standardization documents: see CE Technical file at: see TF This electro-tool was manufactured with high precision and subjected to rigorous factory quality controls. [. . . ]