User manual KRESS ABS 132

[. . . ] User action Action for working with the device, start with light pressure and increase the pressure slowly until the desired operation is achieved. General safety instructions for power tools wARNING!Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. [. . . ] Contact with the saw blade can lead to injuries. apply the machine to the workpiece only when switched on. Otherwise there is danger of kickback when the cutting tool jams in the workpiece. Pay attention that the base plate rests securely on the material while sawing. A jammed saw blade can break or lead to kickback. When the cut is completed, switch off the machine and then pull the saw blade out of the cut only after it has come to a standstill. In this manner you can avoid kickback and can place down the machine securely. Bent or unsharp saw blades can break or cause kickback. Do not brake the saw blade to a stop by applying side pressure after switching off. The saw blade can be damaged, break or cause kickback. Use suitable detectors to determine if utility lines are hidden in the work area or call the local utility company for assistance. Connect mains cable module if necessary If using an extension cable: Only use extension cables specifically approved for the application with the required cross-section. Otherwise the power of the tool can be reduced and the cable can overheat. If the mains cable is damaged while working, pull the mains plug immediately. Fixed power supply Fixed power supply Damaged mains cables must not be used. They must be replaced immediately by an expert technician. Do not attempt to operate other machines with the module. damaged mains cable modules must not be used. They must be replaced by a new Kress mains cable module immediately. Push the two unlocking buttons 13 and remove the mains cable module 12 from the handle. Use only an original Kress mains cable module and at least a heavy rubber tube cable (H07RN-F). -NOTEAfter longer periods of work at low stroke rate, the machine can heat up considerably. [. . . ] Selecting a Saw Blade Only original Kress saw blades as listed in the operating manual or in accordance with the following sketch with a max. This is the only way to guarantee that the saw blade is securely fastened and reduce as far as possible the risk of accidents caused by the jigsaw blades becoming loose. -NOTEIn extreme working conditions, conductive dust can accumulate in the interior of the machine when working with metal. the protective insulation of the machine can be degraded. [. . . ]