User manual KRESS CDS 6425

[. . . ] Keep the machine dry when working outdoors. It is essential to wear a mask when grinding for a prolonged period without a dust extraction unit. The use of ear protection is recommended during longer grinding sessions. The unit must only be used for dry grinding! [. . . ] For heavy dirt accumulation clean grinding disc! The grinding tools are simply pressed onto the grinding disc or flap attachment. The bore holes of the abrasive paper and the grinding disc will automatically coincide when fitted properly. This facilitates the trouble-free extraction of sanding dust when using a vacuum cleaner. Begin with coarse paper, gradually replacing it with finer paper until the desired grinding results have been achieved. We recommend slightly overlapping one piece with the other piece. When grinding, simply guide the machine while pressing down slightly. We do not recommend pressing down heavily on the machine, as higher working pressure reduces the number of strokes and consequently the grinding performance. The machine should be turned on before it is applied to the work piece and should not be turned off until it has been removed from the work piece after grinding (grain marks due to slowdown). It allows you to optimally adjust the speed to the work piece and the applied abrasive paper and is controlled by means of the adjusting wheel (2). The working speed is dependent upon numerous factors (e. As with all service work, brush replacement is carried out quickly and easily by our service locations. They should be replaced immediately at an authorised KRESS Service Point With the CDS 6425 EXL thanks to the innovative mains cable with patent quick-release lock (6) it is possible for you to replace the cable with the greatest of ease. Press the two lock pushbuttons (5) and pull the mains cable (6) out of the casing. Feed the new mains cable into the hand grip until it snaps in place. Various cable lengths are available upon request. Only use the mains cable with patent quick-release lock for KRESS power tools!Do not attempt to operate other electrical appliances with it! faulty mains cables may only be repaired at an authorised KRESS Service Point. Optional accessories: Spare grinding disc Flap attachment Abrasive paper, triangular/K 60­400 Abrasive paper, hexagonal/K 60­400 (make sure that the size is correct) Noise/vibration information: Measured values determined according to EN 60745. [. . . ] Parts which have been replaced become our property. The guarantee will be rendered void if the device is used improperly, mistreated or opened up by unauthorised repair personnel. Parts which are subject to wear are not covered by the guarantee. The guarantee may only be enforced when defects are reported without undue delay (including shipping damage). [. . . ]