User manual KRESS CST 6235 E

[. . . ] Always guide the cable away from the machine to the back. Double insulation Our equipment is designed in accordance with European regulations (EN standards) for the utmost safety of the user. Machines with double insulation always carry the international symbol. The machines are interference-suppressed in accordance with EN 55014. [. . . ] When sawing metals, put some oil onto the cutting line. sheet metal is to be clamped to a suitably solid base (clamping plate or plywood plate). This eliminates as far as possible the risk of the material springing back and forth. A starting point where the saw can be inserted. Plunge cuts can be made into the material (only when working wood), but should only be attempted by skilled people. The switched-on jigsaw is placed on the work piece at an angle of 55­60° to the front edge of the base plate and pushed down slowly and carefully. Particular care is required at the start of this work; kick-backs and jerks will result if the jigsaw is placed the wrong way, whilst excessively fast plunge cuts may result in broken blades. 4 Mitre cuts The base plate can be adjusted in both directions by 22. 5° and 45° angles can be fixed securely. adjustments are made by loosening the clamping wheel (6) beneath the handle. As soon as the toothed wheel work of the saw bench mounting is released, the base plate (4) can be turned to positions 22. 5° or 45° and be tightened again with the clamping wheel (6). 5 Full-wave control electronics The electronic pendulum jigsaw is equipped with control electronics which can be switched off. The stroke rate can be continuously adopted within a range from 450-2000 strokes per minute to the respective material requirements. adjustment is by means of an electronic-adjusting wheel (2) in the housing. This is possible at any time during operation. The electronics are switched off by turning the adjusting wheel to the max. The motor can become overheated with longterm heaving loading and low rev. Chip-flyoff guard The synthetic part is placed into the saw opening of the base plate from below (snap fastening). The wood fibre structure is thereby pressed during sawing against this chip-flyoff guard, thus preventing the wood fibres from being damaged. This application can only be used when cutting at a right angle (90°). In order to keep the cut free of shavings, the flexible suction tube is inserted from the back into the housing opening. [. . . ] Parts which have been replaced become our property. The guarantee will be rendered void if the device is used improperly, mistreated or opened up by unauthorised repair personnel. Parts which are subject to wear are not covered by the guarantee. The guarantee may only be enforced when defects are reported without undue delay (including shipping damage). [. . . ]