User manual KRESS MSL 60-2

[. . . ] The computer-monitored charging process guarantees optimum charging safety, as well as the maximum service life and utilisation of the battery capacity. The application possibilities for the battery charger can be found in the tabulated overview at the end of these operating instructions. When using battery-driven tools basic safety precautions are to be taken, including the following, in order to reduce the risk of fire, batteries leaking and persons becoming injured. Before operating the machine, please read through the operating instructions completely, follow the Safety Instructions in this manual as well as the general Safety Instructions for Power Tools in the accompanying booklet. [. . . ] Remove the battery from the charger and reconnect or allow to cool off to room temperature, then recommence charging. Blinking red ligh: The battery is defective or there is a short between the charging contacts. English Battery charging unit Type: MSL 60/2 6 Use as Intended The device is only designed for charging Kress batteries with voltages between 7. Both NiCd batteries and NiMH batteries can be charged. The application possibilities for the battery charger can be found in the tabulated overview at the end of these operating instructions. Putting into Operation Remove the battery from the device as described in the pertaining operating instructions. Charging Procedure The charging process begins as soon as the mains plug is inserted into the power supply socket and the battery is placed into battery charger slot. The "intelligent" battery charger recognises the charged condition of the battery and switches a fully charged battery immediately to trickle charging. By means of this charging process, the battery is protected and always fully charged. Rapid charging is only possible when the temperature of the battery is between +5 °C and +45 °C. the charging unit it suitable for continuous operation. Display and Key Constant yellow light: The device is ready for use; there is no battery in the charging slot. Constant red light: The battery is too hot or too cold. the charging process begins automatically as soon as the battery is in the permissible temperature range. Blinking red ligh: The battery is defective or there is a short between the charging contacts. Use as Intended The device is only designed for charging Kress NiCd batteries with voltages between 7. The application possibilities for the battery charger can be found in the tabulated overview at the end of these operating instructions. Putting into Operation Remove the battery from the device as described in the pertaining operating instructions. Charging Procedure The quick, computerised battery charger has an extensive function for monitoring the battery and charging parameters and charges the battery with the optimum quick-charging current in each case, depending upon the temperature. This enables the shortest charging times and a long battery service life. After completion of the quick charging process, the charging unit switches automatically to trickle charging. this compensates for the natural self-discharging of the battery. [. . . ] Do not throw used batteries in household waste, in fire or in water. Do not open battery and dispose of it through the available collection points. Give your worn-out Kress machine to your dealer or send it directly to Kress. Subject to change without notice Lire entièrement la notice d'utilisation avant de mettre la machine en service, respecter les consignes de sécurité de cette notice, de même que les consignes de sécurité générales relatives aux outils électriques dispensées dans la brochure fournie avec la notice. [. . . ]