User manual KRESS PH 500

[. . . ] Pneumatic Drill Hammer Article number Input power Output power Half-wave control No-load speed Speed under load No-load impact rate Load hammer blows Impact energie Right/Left rotation Clamping collar dia. Wood Sheet metal Corner measure Weight Protection class For operation, noise protection measures are required. Accessories illustrated or described are not always included as standard delivery items. Take hold of the rotational direction switch 6 on both sides. [. . . ] For drilling work in metal, wood and plastic with drills that have normal shafts, a drill chuck (13 mm max. All common drill chucks with 1/2" x 20 UNF internal threads (13 mm max. MOUNTING THE CHUCK Before any work on the machine itself, pull the mains plug! clean the threads of the drill chuck (accessory) and the adapter 13 (accessory). Screw the drill chuck onto the adapter and tighten firmly (approx. Clamp an Allen key in the drill chuck and use it to tighten the chuck. SCREWDRIVING Screwdriver bits can be inserted into the adapter 13 (accessory). The screwdriver bits are held in the adapter with a spring ring. If the drilling tool become jammed or get caught, the slip clutch releases. Remove the load from the machine immediately by pulling back the drilling tool. Always hold the machine tightly with both hands and assume a secure stance. Before any work on the machine itself, pull the mains plug! always keep the ventilation slots clean. Wipe off the accessible plastic parts regularly with a cloth without cleaning agent. After heavy use over a long period, the machine should be taken to a Kress service location for an inspection and thorough cleaning. Do not drill into hidden electrical lines or gas and water pipes. Check the area to be worked with a metal detector, for example, before starting. For metal, use only flawless, sharpened drills; for stone and concrete, only masonry drills with hard metal inserts. Always adapt the speed to the material to be worked and the diameter of the drill. For precision working with metal and wood, place the machine in a drill stand (accessory). [. . . ] We reserve the right to repair defective parts or replace them with new parts. Improper use or handling as well as opening of the machine by unauthorised repair agencies voids the guarantee. Parts subject to wear are excluded from the guarantee. The guarantee may only be enforced when defects are reported without undue delay (including shipping damage). [. . . ]