User manual KRESS WS 1100 E

[. . . ] please note the points regarding use of the spring flange in the operating instructions. Intermediate shims may not be used on conical or offset grinding wheels. When mounting recessed abrasive wheels, the diameter of the spring flange must be at least 5 mm smaller than the diameter of the flat recess surface of the abrasive wheel and must not press on the transitional curve of the recess. The location holes of grinding wheels must not be subsequently bored because of the danger of breakage this involves. [. . . ] The adjusting nut must be made just tight enough to hold the grinding wheel firmly in place. A new grinding wheel or any newly mounted grinding wheel must be allowed to run idle for half a minute in the machine it is to be used on. Operating and other personnel must stand outside the danger area during the trial area. Grinding wheels must not be be brought to a stop by applying pressure to the periphery or to the face of the wheel. If, during the installation of flanges, a bushing happens to be present, it must be ensured that it does not protrude so far over the sides of the abra-sive wheels as to touch the flange. Cutting off and grinding may only be carried out with the protective cover on!Before every change of a grinding wheel the mains plug must be pulled!Always work with the additional grip attached. The dust produced when working with crystalline silicic acid is harmful to health. Do not use the grinder on any material containing asbestos. Also applicable to this tool are the separately enclosed safety notes, which we recommend following. A spindle lock makes loosening and tightening the clamping flange (10) with the pin-type face wrench easier. When doing this, hold the pusher (11) pressed in. Replacing the carbon brushes Our service personnel will carry out this and all other servicing work quickly and professionally. They should be replaced immediately at an authorised service point. accessories included in delivery 1 pin-type face wrench Noise/vibration information Measured values correspond with EN 50144. Sound pressure level: 82, 5 +3 dB (A) Sound power level: 95, 5 +3 dB (A) Work place emission value: 85, 5 +3 dB (A) Operators require noise protection equipment. The acceleration measured is usually less than 2. Special equipment Roughing discs for stones and non-ferrous metals Roughing disc for steel and castings Cutting disc for stones Adhesive grinding disc, complete set Adhesive fleece (K 180) Adhesive supporting disc M 14 Vulcanized fiber discs, complete set Supporting disc with clamping flange for vulcanized fiber discs Steel wire cup-shaped brush Environmental protection Kress takes back used machines for resource saving recycling. Can be very easily broken down into their recyclable basic materials. Hand in your old Kress machine at a dealer or send them directly to Kress. Consignes de sécurité et protection contre les accidents Parcourir entièrement la notice d'utilisation avant de mettre la machine en service, suivre les consignes de sécurité de cette notice, de même que les consignes de sécurité générales relatives aux outils électriques dispensées dans la brochure fournie avec la notice. [. . . ] Lämna tillbaka skrotade Kressmaskiner till affären eller skicka in dem till Kress. This electrical tool has been designed with high precision and was approved after undergoing strict quality control checks in the factory. We are therefore able to guarantee free servicing of any production or material faults which arise in the 24 months after the date of sale to the purchaser. We reserve the right to repair defective parts or else replace them with new parts. [. . . ]