User manual KRUPS 458

[. . . ] 0 To disconnect, turn switch to "OFF", then remove plug from wall outlet. 0 Do not use appliance for other than intended use. 0 Snap lid securely onto glass carafe before serving beverages. 0 Do not remove glass carafe from heating plate while water is dripping from the spout. [. . . ] Set the hour and minutes by pressing the `h' and "min. " buttons respectively (see figure 2). The time is now set. Before making your first pot of delicious coffee, we recommend operating the coffeemaker one or twice with water only, without ground coffee or a paper filter to remove any possible dust. 0 Be sure that the water container is empty. 0 The lid of the glass carafe must be properly positioned during the brewing process. Position the lid over the carafe and snap into place (see figure 3). 0 Place carafe directly underneath brewing spout (see figure 4). Filling the water chamber Open the hinged lid (see figure 5). Using the glass carafe, pour in the desired quantity of water (see figure 6). The water level indicator shows how much water you are filling into the container. The amount of freshly brewed coffee delivered after the brewing process will always be slightly less than the amount of put into the water container. This is due to the minimum absorption of the water by the ground coffee. 7 Therefore, it is recommended that you add a little extra water at the beginning so that you will have the number of cups you desire. Replace the glass carafe on the warming plate with the carafe lid in position. Potting in the ground coffee With the hinged lid opened, insert a paper filter (we recommend KRUPS size 4) into the filter holder, with the seam facing right (see figure 7). We suggest using one level KRUPS measuring scoop of ground coffee for each cup of robust coffee (see figure 8). After using your KRUPS coffeemaker several times, you can adjust the measure to suit your own taste. Close the hinged lid, making sure that the filter holder is securely in place. The "Stop'n Serve" feature is KRUPS answer to the impatient coffee drinker's clamor for "a quick cup of coffee!". This device automatically stops the flow of brewed coffee through the filter cone if the glass carafe is removed from the warming plate during the brewing cycle. You have about 20 seconds between the removal of the carafe and its being reinserted to allow the service of one or two cups of coffee. The "Stop'n Serve" device closes off the filter cone so effectively that there is virtually no coffee-drip onto the warming plate (one drop, at most). Once the carafe is replaced, the brewing cycle and the flow of coffee into the carafe are resumed. A CAUTION: The KRUPS "Crystal Arome" features a full flavor selector button. If you want to make l-3 cups of coffee, press the `l-3' button (see figure 9). This will extend the brewing cycle so that the water will seep into the ground coffee slowly enough to yield brewed coffee that is rich, aromatic and truly delicious. [. . . ] 0 This is due to the calcium (limestone) found in drinking water. This warranty gives you specific legal rights, and you may also have other rights which may van/ from state to state. 11 GUARANTEE OF PERFORMANCE This fine KRUPS product is manufactured according to a rigid code of quality standards, and, with minimum care, should give years of satisfying service. However, should the need arise for repairs or for replacement parts within or after the warrantv period, please call our CONSUMER SERVICE DEPARTMENT: (8001 526-5377 24-hours a day, 7 days a week You will be provided with specific instruction on how to get your product repaired, as well as the name and address of your nearest authorized KRUPS Service Center. The department will also be able to answer any general product questions you may have. [. . . ]