User manual KRUPS 963

[. . . ] When cut off, this plug is a shock hazard if inserted into a socket outlet and must therefore be disposed of safely. If the fuse cover is detachable, never use the plug with the cover omitted. Replacement covers can be obtained from your service agent. Fit the appropriate plug according to the instructions in paragraph «Fitting a plug». [. . . ] The following espresso may be prepared by refilling the filter. As soon as water flows from the percolation head, the boiler is full. If the water boiler empties itself during the preparation of the steam (steam stops coming out of the evacuation pipe), it must be refilled. ⷠTo do this, turn the steam tap to position O, place a container under the percolation head and set the pump switch to the « » position. ⷠAllow the water to flow from the percolation head until the yellow light goes on ; then reset the pump switch to position . ⷠWait until the yellow light has gone out before resuming steam production by slowly turning the steam tap to the max position. Steam can be used to make the milk frothy for a cappuccino or for heating liquids. The temperature required to produce steam being higher than that necessary to make an espresso, the espresso should always be prepared first, because otherwise the coffee might be burnt. The nature of the system is such that a little water, which can be collected in a separate container, will escape from the steam nozzle before the steam appears. Fill the water tank with fresh water (1) (2) (3). Set the pump switch to the « » position and wait until a small amount of water flows out, which means the boiler is full. The water tank must be emptied after use. ⷠRemove the cup rest grid and clean it (20). ⷠEmpty the drip tray and clean it. The percolation head, the filter holder and the filters must be cleaned after each use : · First, allow the appliance to cool down, then wipe the percolation head with a damp cloth. Each detachable element can be rinsed under running water. ⷠDo not clean the filter holder or the cup rest grid in the dishwasher. ⷠIf the percolation head is very dirty, unscrew the percolation head using a coin : the valve spring and sealing gasket will also come off. ⷠClean the grid and wipe the percolation head with a damp cloth. Make sure the valve spring and the sealing gasket are correctly positioned (21). Important : After making frothy milk, clean the steam nozzle immediately by allowing the appliance to produce steam for 1 to 2 seconds. If the pipe and the tip have been completely obstructed, clean these using a needle. [. . . ] Allow about half of the descaling solution to run through, then reset the pump switch to position. When the steam appears, turn the tap back to O position. ⷠLeave the remainder of the descaling solution to work on the interior of the machine for 10 to 15 minutes. Allow the descaling solution to run through completely, then reset the pump switch to position. [. . . ]