User manual KRUPS 966

[. . . ] S The mains plug must be pulled out if anything unusual occurs during the brewing process, and always before any cleaning operation, or if the appliance does not function properly. S Do not use the flex to pull out the mains plug. s Do not lay or hang the flex over edges or corners. S Neither you nor the mains flex should ever touch hot parts of the appliance. [. . . ] Using ready-ground coffee-meal You have already prepared the appliance. When the rinsing process is finished, the following lamps will glow: "rinse"; "1 cup normal"; "1 cup strong"; "2 cups"; "coffee-meal". S Open the lid of the coffee feed funnel and put in one or two level measuring spoonfuls of espresso- or coffee-meal (16). Do not put more than two level measuring spoonfuls into the feed funnel. the funnel is not a storage receptacle. Neither should you put in less than one level measuring spoonful, otherwise the espresso or coffee delivery will be automatically interrupted. Use only ground coffee-beans and not instant coffee or drink powders. Appliance indicator(s) Breaking off the brewing process If you wish to break off the brewing process before it is completed, actuate any one of the following keys: , , , or . The process then will be stopped and the spent coffee automatically thrown out. Emptying the spent coffee holder and the drawer The spent coffee holder receives the used coffee-meal and the drawer takes up any remaining water. S If the "empty spent coffee holder" indicator glows, raise the drawer slightly and then pull it out (18). When the pre-heating is completed, the "steam" indicator will glow and you can commence the production of steam. S When the liquid is sufficiently heated, turn the knob back to the position and remove the vessel. S Clean the steam nozzle with a moist cloth immediately after the heating operation is finished. S To remove any eventual residues from the steam nozzle, place a receptacle beneath the nozzle and turn the knob for steam/hot water to the position for just a moment. Concluding the production of steam The preparedness of the appliance to produce steam can be cancelled in 2 different ways: 1. s After steam has been produced , turn the selector knob for steam/hot water to the position. After about 10 minutes, the appliance will automatically cease to be ready for steam production and the "ON/OFF"and "steam" indicators will blink. If you want to prepare espresso or coffee immediately after producing steam: s After the steam has been produced, turn the selector knob for steam/hot water to the position. Turn off the steam pre-selection by pressing the steam pre-selector key , whereby the "ON/OFF" and "steam" indicators will blink. In order to prepare espresso or coffee as usual, you must either cool down the appliance from the steam temperature to the espresso and coffee temperature, or fill the heating system. S Return the selector knob for steam/hot water to the position, whereby the "ON/OFF", "rinse", "1 cup normal", "1 cup strong", "2 cups" and "coffee-meal" indicators will glow. [. . . ] S When the "fill water tank" and "empty spent coffee holder" glow, rinse out the water tank thoroughly. Fill the tank with fresh water (at least 1 litre a good half tankful) and return it to the appliance. S Remove the drawer, empty it and return it to the appliance. the "ON/OFF" and "steam" indicators will blink. [. . . ]