User manual KRUPS CITIZ CO

[. . . ] Drink your espresso from small porcelain cups rather than the usual coffee cup or mug. To obtain an espresso at just the right temperature and a nice compact creamy top, we advise you to pre-heat your cup. After a few trial runs you will find the type of mix and roast of the coffee beans that suits your taste. The quality of the water used is obviously another essential factor in the coffee you get. [. . . ] Once the pre-heating phase has been completed, a message will ask you to place a recipient under the steam nozzle. Press the "steam" key again to start generating steam. A little water will be produced first and then steam will start. Use the same key to stop steam generation. 7 FROTHING MILK We advise you to use very fresh milk. The milk and its recipient must be cold, ideally between 6 and 10 °C. The coffee cleaning tray allows you to eliminate any deposits of coffee grounds above the percolation chamber. If the above message Remove the coffee appears, remove, empty cleaning tray. and clean the drip tray. Clean it under water and dry thoroughly before re-fitting. Remove, empty and clean the coffee grounds collector. The drip tray is equipped with floats to tell you when to empty it. As soon as you remove the coffee grounds collector, you will have to empty it completely to avoid any overflow. The warning message will remain displayed if the coffee grounds collector is not slotted in fully or not fitted correctly. If the coffee grounds collector is fitted within less than 8 seconds, the appliance will ask you to confirm that you have correctly emptied it. You cannot make espresso or coffee while the warning message is displayed. The coffee grounds collector has a maximum capacity of 12 coffees. AUTOMATIC CLEANING PROGRAM ­ TOTAL DURATION: ABOUT 20 MINUTES You should perform the cleaning program about every 360 preparations of espresso or coffee. Press to perform cleaning at any time and then choose MAINTENANCE => OK => SCALE REMOVAL from the menus displayed. Only use KRUPS scale removal products, citric acid or tartaric acid. You can obtain scale removal products from KRUPS Service Centres. In no event must you use conventional starchy sulphonic acid or other products containing that acid. The manufacturer may not be held responsible for damage to the appliance through use of other products. If the coffee grounds collector is not fitted you will be warned by a message being displayed. Fit the collector again for the cycle to continue automatically. If a power failure occurs during the cycle, you will have to start it again right from the beginning. You will not be able to postpone this operation. Be sure to complete the entire scale removal cycle to avoid any risk of intoxication. The scale removal cycle is a discontinuous cycle. Do not put your hands under the coffee outlets during the cycle. Make certain to protect your work surface during scale removal cycles, especially if they are made of marble, stone or wood. GENERAL MAINTENANCE Always remove the power supply cord from the socket and let your appliance cool down before cleaning it. Do not use utensils or cleaning products likely to scratch or corrode the appliance. [. . . ] Check that the cleaning tray is correctly pushed in. A power failure occurred during a cycle. The appliance will re-initialise automatically when power is turned on and be ready for a new cycle. There is water or coffee under the The drip tray is overflowing. [. . . ]