User manual KRUPS DOLCEGUSTO

[. . . ] Do not leave this appliance within reach of unsupervised children. The use of this appliance by young children or by disabled persons must be supervised at all times. Check that the voltage indicated on the information plate on the appliance does in fact match that of your electrical system. K and Ireland only : APPLIANCES WITH FITTED PLUG Important : For your convenience this appliance is supplied complete with a plug incorporating a 13 amp fuse. [. . . ] If necessary repeat the operation until the tank has been completely emptied. Using the various functions of your appliance Fill the tank (a) with fresh water (1) and set the switch (c) to «I». Raise the handle (f1) to open the capsuleholder head (f) (2). Once the appliance reaches the correct temperature, the temperature indicator light (e) becomes fixed (green). Take the water tank (a) and fill it with cold water (1). Raise the handle (f1) to eject the used capsule which will automatically be collected in the container (j). This container can hold a maximum of 12 capsules. We advise you to empty it at regular intervals. tips : · Water quality is vital for a good espresso, so we recommend that you use only fresh cold water. Preheat the cups before making espresso, as this will help it to retain its temperature. A simple way to do this : first fill the cups with hot water (see paragraph «The Hot Water Function »). Place a cup beneath the coffee outlet, and the capsule holder head must be closed and empty. Once the cup is full, reset the function selector (b) to the central position. As soon as the temperature indicator light (e) becomes fixed (green), you can start to prepare an espresso or hot water. Fill the tank (a) with fresh water (1) and position the switch (c) to «I». the temperature indicator light (e) flashes (green). Once the appliance reaches the correct temperature, the temperature indicator light (e) becomes fixed (green). Follow this operation to preheat cups before making an espresso. If necessary, clean the drip tray with hot water and a little non-abrasive washing-up liquid, rinse and dry. When refitting, put back the container, the indicator then the grille. The steam / hot water nozzle (g) Be careful : it may still be burning hot. Clean the nozzle after every use using a damp cloth. [. . . ] The fill indicator (i1), indicates when to empty the tray. Remove the grille and the fill indicator (i1), take out the container and empty the drip tray (6). Allow 1/3 of the descaling solution to run through. Leave the product to work for about five minutes. [. . . ]