User manual KRUPS EA8000PN

[. . . ] hOTLINE UK 0845 330 6460 ROI (01) 677 4003 Eλλη νικά PORTUGUÊS ESPAÑOL ITALIANO NEDERLANDS DEUTSCH ENGLISH FRANCAIS Lights Empty the Fill tank coffee grounds collector Clean Calc On / Off Meaning The appliance is ready for a coffee or steam cycle. / / Slow flashing: the device is in the preheating phase or an initialisation cycle. / / / Empty the coffee grounds collector (a 2 coffee cycle is underway). Empty the coffee grounds collector + clean the drawer + empty the drip tray. [. . . ] To prevent milk from drying on the auto-cappuccino accessory, it must be cleaned thoroughly. It is recommend that you wash it immediately by carrying out a cycle with steam and the accessory pot filled with water in order to clean the inside of the nozzle. To do so, you can use liquid cleaner XS4000, available as an accessory. 7 MAINTAINING YOUR APPLIANCE EMPTYING THE COFFEE GROUNDS COLLECTOR, THE COFFEE TRAY AND THE DRIP TRAY The drip tray receives waste water and the coffee grounds collector receives used coffee grounds. The coffee cleaning tray allows you to eliminate any deposits of coffee grounds. If the light comes on, remove, empty and clean the drip tray. Clean it under water and dry thoroughly. Remove, empty and clean the coffee grounds collector. The drip tray is equipped with floats to tell you when to empty it. As soon as you remove the coffee grounds collector, you will have to empty it completely to avoid any overflow. The light will remain on if the coffee grounds collector is not slotted in fully or not fitted correctly or if it has been put back in less than 4 seconds. 3 – Second rinsing ± 5 mn The ‘clean’ light again becomes steady. A second cleaning cycle will be run automatically. This second rinsing cycle lasts about 5 minutes. Once the second rinsing cycle has finished, the ‘clean’ light will go off. Empty your waste water receptacle and put it back under the coffee outlets. Again press the ‘Service’ button to start the second rinsing cycle. Your appliance will be ready for use again. remove and empty your waste water receptacle. If there is not enough water in the water tank when you start the program, the light will come on to warn you. Add the appropriate amount of water to the container and cleaning will continue automatically. If you press the key during cleaning or in the event of power failure, you will have to restart the cleaning program right from the start. [. . . ] A power failure occurred during a cycle. The appliance will re-initialise automatically when power is turned on and be ready for a new cycle. There is water or coffee under the appliance. Check for correct positioning of the drip tray The 4 red lights flash permanently. [. . . ]