User manual KRUPS ESPRESSO NOVO 2000 PLUS 984

[. . . ] KRU PS Espresso NOVO 2000 PIUS Model#984 Instruction Book Warranty -- Hi -- -l Guarantee of Performance IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or injury to persons, including the following: 0 Read all instructions and information in this instruction book and any other literature included in this carton referring to this product before operating or using this appliance. 0 To protect against fire, electric shock and personal injury do not immerse cord, plugs, or appliance in water or other liquid. 0 Close supervision is necessary when any appliance is used by or near children. 0 Unplug from outlet when not in use and before cleaning. [. . . ] Choose the desired filter basket which is required for making one or two cups of espresso and insert filter holder (see figure 9). Depending upon which filter basket you have chosen, add one measuring spoon of espresso coffee for each cup of espresso that you are preparing (see figure 10). l Fill the water container with fresh, cold water (see figure I-3). While making espresso, water can be added to the reservoir by opening the hinged water chamber lid and adding water to the water reservoir, using another receptacle to fill the container, Otherwise, the water reservoir can be removed and taken to the faucet. l l The one cup filter basket only requires one lecel KRUPS measuring spoon of espresso coffee. The two cup filter basket only requires two KRUPS measuring spoons of espresso coffee. L"rl CAUTION: IF THE WATER RESERVOIR IS EMPTY AND THE PUMP IS RUNNING, YOU WILL HEAR A VERY DISTINCT NOISE, WHICH IS LOUDER THAN THE NORMAL OPERATING SOUND. IF THIS HAPPENS, TURN THE MACHINE "OFF". CHECK WATER RESERVOIR AND REFILL AS NEEDED. NEVER LET THE PUMP RUN WHEN THE WATER RESERVOIR IS EMPTY AS THIS CAN DAMAGE THE PUMP. Prewarming Espresso/ Cappuccino Cups If the machine is being used for the first time during the day, we recommend prewarming your cups with hot water (see figure 8). After you have made several cups of espresso, the cups can be prewarmed on the warming plate (b) of your Espresso Novo 2000 Plus. Make sure that you do not overfill the filter basket, and that you use the measuring spoon Im) to press your coffee to the proper consistency for brewing (see figure 11). It is also very important that you remove any coffee that might have fallen onto the rim of the filter holder, while you were filling or tamping the coffee (see figure 12). Insert filter holder back into the machine by raising it up at a 45 degree angle and turning it to the right. Turn the filter holder to the right, until it is firmly locked into place. The marking located on the center of the filter holder handle must be within the "lockrange" indicated on the lower edge of the front panel (see figure 13). J Place a cup which has at least a 2-2, 5 oz. capacity underneath the filter holder spout. If you are preparing more than one cup of IO . espresso, be sure to position two cups underneath the brewing spouts. When preparing cappucino, you will need a cup that has at least a 5 oz. As soon as the yellow thermosF, aGight goes " position out turn the control dial to the ( see figure 14). When the desired amount of espresso is in the cup(s), turn the control dial back to the "0" position. To remove the coffee from the filter basket, remove the filter holder from the machine by grasping the filter holder and turning it to the left, until it dislodges. Dispose of used coffee in a waste receptacle (see figure 15). Reinsert the empty filter holder back into the machine to help keep it warm. If you are preparing more than one cup of espresso, disregard the yellow thermostat light. [. . . ] If the seal has lost its elasticity, it must be replaced with a new one. Allow the appliance to cool down and then unscrew the sieve from the brewing head. Re-move the seal carefully from the brewing head using a screw driver. Place the new seal onto the machine and then place the flattened side of the sieve back into brewing head. l l 14 Problem: Pump makes loud noise. [. . . ]