User manual KRUPS NESPRESSO FNA1

[. . . ] The wire which is coloured BLUE must be connected to the terminal which is marked with the letter `N' or coloured black. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter `L' or coloured red. This appliance is manufactured to conform to the Low Voltage Electrical Equipment (Safety) Regulations 1989 and is designed to comply with BS 3456. A b c d e f f1 f2 f3 g h i i1 j Removable water tank with lid Function selector Start/ stop switch «Steam» function button « » Temperature indicator light Capsule holder head opening and closing handle capsule cage capsule holder Steam /hot water nozzle Cappuccino accessory Drip tray with removable grille fill indicator Container for used capsules Please read these instructions carefully before using your appliance for the first time and retain them for future use: any use which does not conform to the instructions will absolve KRUPS from any liability. [. . . ] Easily obtain milk with more or less froth to make a cappuccino or a café crème, . Cappuccino : 1/3 coffee, 1/3 hot milk, 1/3 milk foam. Café crème : 1/2 coffee, 1/2 hot milk, not too frothy. The tip must not touch the bottom of the container so as not to prevent the passage of steam. Once you have obtained the foam, reset the function selector (b) to the central position and remove your jug. Immediately after use, remove the cappuccino accessory (h) and clean the steam/hot water nozzle (g) using a damp sponge. You can also produce steam for a moment, pointing the nozzle (g) towards the grille, in order to eliminate any remaining trace of milk. Fill the tank (a) with fresh water (1) and position the switch (c) to «I». Press the « » function button (d) : the temperature indicator light (e) turns yellow and flashes. Once the appliance reaches the correct temperature, the temperature indicator light (e) becomes fixed (yellow). Then immerse the tip of the steam/hot water nozzle (g) in the container holding the liquid to be heated (5). For any liquid other than water, clean the steam/hot water nozzle (g) immediately after use with a damp sponge. You can also produce steam for a moment, pointing the nozzle (g) towards the grille, in order to eliminate any remaining trace. This accessory must only be used for foaming milk. Fill the tank (a) with fresh water (1) and position the switch (c) to «I». Press the « » function button (d) : The temperature indicator light (e) turns yellow and flashes. Pour the desired quantity of skimmed or semi-skimmed milk into a narrow jug which will fit beneath the nozzle (g). Both the milk and the jug should be nice and cold. Once the appliance reaches the correct temperature, the temperature indicator light (e) becomes fixed (yellow). Caution: during and after steam operation, the nozzle (g) is very hot. When you no longer wish to use the steam function : . The temperature e indicator light (e) turns green again and flashes. [. . . ] Repeat this operation twice more until the descaling solution has been completely emptied. Allow the contents of the tank to flow through so as to rinse the water system of the appliance. Raise the handle (f1) to open the capsuleholder head (f). The appliance takes The appliance a long time to needs descaling. [. . . ]