User manual KRUPS PREMIUM 253

[. . . ] 0 Do not allow the cord to touch any hot part of the appliance. 3 l The use of an accessory not evaluated for use with this appliance may cause injuries. 0 Do not use outdoors. 0 Do not let cord hang over edge of table or counter, or touch hot surfaces. 0 Do not place on or near a hot gas or electric burner, or in a heated oven. l To disconnect, turn switch to "OFF", then remove plug from wall outlet. 0 Do not use appliance for other than intended use. 0 Snap lid securely onto glass carafe before serving beverages. l Appliance with glass carafe: A. [. . . ] Note: Excess water in the water tank cannot be poured out of the appliance. To eliminate any excess water, allow the coffee maker to operate without coffee grounds. Putting in the ground coffee W Press the release button and swing out the 2-part filter holder (figure 4). n Insert the KRUPS goldtone filter into the filter insert (figure 5). W "Stop'n Serve" feature lets you pour a cup or two while brewing. The automatic filter seal will allow you to remove the carafe for 20 seconds without dripping coffee onto the warming plate. W Stainless steel anti-drip spout prevents coffee spillage when pouring from any angle. W Water level indicator is easy to read. W Hinged water chamber lid protects water from dust and dirt. W Hidden cord storage allows you to set the cord length you need. n Goidtone filter eliminates coffee sediment for best coffee results. If you desire, you can use paper filters instead of the goldtone filter. We recommend using KRUPS size 4 filters. We suggest using one level KRUPS measuring scoop of ground coffee for each cup of robust coffee. After using your KRUPS coffeemaker several times, you can adjust the measure to suit your own taste. Before you start Before making your first pot of delicious coffee, we recommend operating the coffeemaker once or twice with water only, without ground coffee or a filter, to remove any possible dust. 8 n Close the filter holder and make sure that it is completely closed (figure 7). Set the carafe lid on the carafe, and replace the carafe on the warming plate. A red indicator light will illuminate and brewing will commence. CAUTION: Never open the filter holder during the brewing process. n This model features a full flavor selector button. If you want to make l-3 cups of coffee, press the flavor selector button (figure 9). so effectively that there is virtually no coffee-drip onto the warming plate (one drop, at most). Once the carafe is replaced, the brewing cycle and the flow of coffee into the carafe are resumed. CAUTION: If coffee does drip onto the warming plate after removal of the carafe, it is usually an indication that too much ground coffee has been placed into the paper filter. This causes the water that jets into the filter cone to overflow between the paper filter and the sides of the filter cone. The overflow carries coffee grounds that interfere with the snap-shut action of the filter holder, thus allowing brewed coffee to continue to drip through. If this blockage and subsequent dripping do occur, replace the glass carafe immediately and allow the full brewing cycle to run its course. [. . . ] Never immerse the appliance itself in water or any other liquid. To clean, simply wipe off with a soft, damp cloth. Never use a cloth to clean the inside of the water chamber, as this might leave fuzzy deposits in the chamber. Just rinse with cold water periodically. [. . . ]