User manual KRUPS PROAROMA 12 TIME 453

[. . . ] This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. [. . . ] The lid is then locked in place. 6 " 'r . Make . sure that the swing away filter (c) is properly closed during the brewing process. When closing the swivel filter you willfeel a noticeable resistance between the swivel filter and the base. Push infirmlyuntil you hear the filter "click" into place. Caution: If the swivel filter is not completely closed, the "Stop'n Serve" trigger will not function properly, which may cause hot water or hot coffee to overflow. the seam pointing towards the handle of the filter holder (see figure. ). Instead of filter paper you can also use the KRUPS goldtone filter (model #053). (When ordering filter paper or the goldtone filter from KRUPS be sure to indicate that they are for model #314). Put ground coffee into the paper filter (see figure. ). We suggest using one level KRUPS measuring spoon of ground coffee for each cup of robust brewed coffee. After using your KRUPS coffee maker several times you can adjust the measure to suit your own taste. Close the swivel filter and make sure that it is completely closed (see figure. ) . . The "Stop'n Serve" mechanism is opened as long as the glass carafe is inserted into the machine and sits properly on the warming plate and the swivel filter is properly closed. & Filling the Water Chamber Open thehinged lid(see figure. ): Pour in the desired quantity of water (see figure"). The water level indicator shows you how much water you are filling into the container. The amount of freshly brewed coffee delivered after the brewing process will always be slightly less than the amount put into the water container. This is due to the minimal absorption of the water by the ground coffee. Once the carafe is pre-heated, the indicator light will stop flashing, but remain solid red. 8 '1 & Caution If the coffee does drip onto the warming plate after removal of the carafe, it is usually an indication that the small seal in the filter holder is missing or defective. It is also possible that too much ground coffee has been placed into the paper filter. This causes the water that jets into the filter cone to overflow between the paper filter and the sides of the filter cone. This overflow carries coffee grounds with it that interfere with the snap-shot action of the filter holder, thus allowing brewed coffee to continue to drip through. If this blockage and subsequent dripping do occur, replace the glass carafe immediately and allow the full brewing cycle to run its course. Do not swing out the swivel filter until the brewing cycle is completed. 3. Once you have set the "Wake-Up" time, either press the "prog" key or wait approximately 4 seconds. The current clock time will reappear and the display colon will flash. To activate "Wake-Up" setting press ~ button. A green light will indicate the "Wake-Up" program has been set. The "Wake-Up" time is now stored in memory. [. . . ] Note: The ProAroma Time may be manually shut off at any time by using the "on/off" button. ) I the coffee will continue to be held at the brewing temperature after brewing, Cleaning . Always unplug this appliance before cleaning. This is of no importance, however, and should be ignored. Decalcification is necessary only when "CALC" appears repeatedly or permanently in the display. The "CALC" display will remain visible until the "on/off" key is pressed. [. . . ]