User manual KRUPS VERTUO NEXT XN9105

[. . . ] 4 Orange light blinking quickly: twice/second: Cleaning mode > see point 6* FR Voyant orange avec clignotement rapide : deux fois/seconde : mode nettoyage > voir point 6* DE Schnelles oranges Blinken: Zwei Mal/Sekunde: Reinigungsmodus > Siehe Punkt 6* IT Luce arancione che lampeggia rapidamente: due volte al secondo: modalità di pulizia > vedere punto 6* ES Luz naranja intermitente a ritmo rápido (dos veces por segundo): Modo de limpieza > ver punto 6* PT Piscar rápido a luz laranja: duas vezes por segundo: preparação de café > veja o ponto 6* PL Szybko migajce pomaraczowe wiatlo: dwa razy na sekund: Tryb czyszczenia > patrz punkt 6* RU (2. 5 Orange light blinking rapidly: three times/second: Descaling/Emptying > see point 6* FR Voyant orange avec clignotement rapide : trois fois/seconde : détartrage/vidange > voir point 6* DE Sehr schnelles oranges Blinken: Drei Mal/Sekunde: Entkalkung/Entleerung > Siehe Punkt 6* IT Luce arancione che lampeggia rapidamente: tre volte al secondo: modalità decalcificazione/svuotamento > vedere punto 6* ES Luz naranja intermitente a ritmo más rápido (tres veces por segundo): Descalcificación/vaciado > ver punto 6* PT Piscar muito rápido a luz laranja: três vezes por 6 White light pulsing up: lighting up to steady ON, then OFF. 7 Orange light pulsing down: fading to OFF, then ON. : Cooling down after overheating > see point 7* FR Voyant orange avec pulsation descendante : le voyant s'éteint lentement, puis se rallume. [. . . ] If you are cleaning, descaling or emptying the system, check that no capsule is inserted then close, lock the machine and push the button to start one of these operations. Fill the water tank and push button to start. If coffee is flowing normally, this indicates the machine is working properly. If only water is flowing, the machine is executing a user request for either cleaning, descaling or emptying the system. Refer to the corresponding paragraph in this user manual. Turn the machine to "OFF mode" by pushing the button for 3 seconds and then push it again to turn the machine ON. Now wait approximately 20 minutes to allow the machine to cool down after extensive use. It will take some time before the coffee flow comes out (due to barcode Reading and pre-wetting the coffee). Check that a fresh capsule is inserted in correct position, that the handle is properly locked and push the button to start. Fill the water tank and push button to start. Turn the machine to "OFF mode" by pushing the button for 3 seconds and then push it again to turn the machine ON. Now wait approximately 20 minutes to allow the machine to cool down after extensive use. During regular Coffee/Espresso preparation: 1) Unlock the handle and Open the machine head to check that a fresh undamaged capsule is During Descaling, Emptying and Cleaning: 1) Check that capsule is ejected. During Programming Volume: 1) Check if a capsule has been well inserted. Disconnect powercord from the outlet and plug the machine back into outlet after 10 seconds. Close the head and press the button to turn ON and press again to start brewing. 12 Light alternately blinking 3 times and then steady on. Descaling needed: machine can be operated when alert appears only a few times after this alert before descaling becomes necessary. [. . . ] Separation of the remaining waste materials into different types facilitates the recycling of valuable raw materials. leave the appliance at a collection point. You can obtain information on disposal from your local authorities. To know more about Nespresso sustainability strategy, go to www. [. . . ]