User manual KRUPS XP2240 10

[. . . ] Com manuals search engine Downloaded from www. Com manuals search engine Downloaded from www. Com manuals search engine Downloaded from www. Com manuals search engine Downloaded from www. [. . . ] Turn the switch to the “steam preheating” position. Turn the steam nozzle towards the outside of the appliance. Pour 60 to 100ml of very fresh, very cold milk into a small container of about 1/2 litre and which can go under the steam nozzle. The milk and its container should be quite cold. We recommend that you use pasteurised or UHT milk and that you avoid untreated milk. As soon as the indicator lamp stops blinking, plunge the steam nozzle into the milk. Turn the switch to the “steam” position (fig. For good results, hold the nozzle at the bottom of the container for about 25 seconds while the milk heats (without however touching the bottom). Then bring the container down gradually so that the nozzle moves up towards the surface (without ever coming out of the milk) (fig. Once the froth has been formed, turn the switch to the “stop” position (fig. The appliance will now automatically cool itself by launching 3 intermittent pumping cycles. do not use alcohol or solvent-based cleaning products. For best results, you can activate the "EJECT" button several times during rinsing. We recommend that you shake the filter holder thoroughly in order to remove all the water. When not using your espresso coffee maker, do not leave the filter holder on it, in order to prevent wear to the joint. For more thorough cleaning, the filter holder can be dismantled: You can remove the black plastic part where the coffee outlets and the "EJECT" button are to be found: turn it to the left and pull sharply (fig. Clean the various components under running water and a little gentle washing-up liquid. Replace the black plastic part in the metal component, turn it to the right until the two arrows on each component line up. If the percolation head is very clogged, unscrew the grid using a Phillips screwdriver, clean it and reassemble it, screwing tightly (fig. OF THE CAPPUCCINO ACCESSORY To clean it, unclip it from its articulated arm by pulling the black ring downwards (fig. This accessory is composed of 3 parts: the inner tube, the outer tube and a stainless steel protection. To clean this accessory, take it apart completely. [. . . ] Place a paper filter in the filter holder and fill it with ground coffee using the measuring spoon, with one spoon per cup of coffee (fig. Press the "on/off" button on the filter coffee maker part, the light comes on, the cycle starts. The filter coffee maker is fitted with an anti-drip appliance which enables you to serve the coffee before it has completely finished running through. If you serve yourself a coffee while the cycle is still running, place the jug back in position quickly to prevent any spillage. [. . . ]