User manual KTM 250 XCF-W ZA 2010

[. . . ] OWNER'S MANUAL 2010 250 EXC-F EU 250 EXC-F AUS 250 EXC-F SIX DAYS EU 250 XCF-W ZA 250 SX-F EU 250 SX-F USA Art. 3211465en DEAR KTM CUSTOMER DEAR KTM CUSTOMER 1 Congratulations on your decision to purchase a KTM motorcycle. You are now the owner of a state-of-the-art sports motorcycle that will give you enormous pleasure if you service and maintain it accordingly. We wish you a lot of enjoyment riding this vehicle! Enter the serial numbers of your vehicle below. [. . . ] 49) ­ Move the handlebar to and fro over the entire steering range. The handlebar must be able to move easily over the entire steering range. No resting locations should be noticeable. » If click positions are noticeable: (SXF, 250 EXC-F SIX DAYS EU) ­ Adjust the play of the steering head bearing. (EXCF EU, EXCF AUS, XCFW ZA) ­ Adjust play of the steering head bearing. 49) Check the steering head bearing and replace if required. 40) ­ Remove the motorcycle from the work stand. ( Adjusting play of steering head bearing 13. 24 x (EXCF EU, EXCF AUS, XCFW ZA) ­ ­ ­ Jack up the motorcycle. Guideline Screw, top steering head ­ ­ Fully tighten screw . Guideline Screw, top triple clamp ­ Tighten screw . Guideline Screw, top steering stem ­ Check the steering head bearing play. 49) 20 Nm (14. 8 lbf ft) M8 20 Nm (14. 8 lbf ft) M20x1. 5 10 Nm (7. 4 lbf ft) Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains. 40) 100022-10 MAINTENANCE WORK ON CHASSIS AND ENGINE Adjusting the play of the steering head bearing 13. 25 50 x (SXF, 250 EXC-F SIX DAYS EU) p. ( (250 EXC-F SIX DAYS EU) ­ Loosen screws . Guideline Screw, top steering head ­ ­ 800022-10 M20x1. 5 10 Nm (7. 4 lbf ft) Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains. Guideline Screw, top triple clamp M8 17 Nm (12. 5 lbf ft) ­ Mount and tighten screw . Guideline Screw, top steering stem M8 17 Nm (12. 5 lbf ft) Loctite® 243TM (SXF) ­ Loosen screws . Guideline Screw, top steering head ­ ­ 600876-10 M20x1. 5 10 Nm (7. 4 lbf ft) Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains. Guideline Screw, top triple clamp M8 17 Nm (12. 5 lbf ft) ­ Mount and tighten screw . Guideline Screw, top steering stem M8 p. 49) 17 Nm (12. 5 lbf ft) Loctite® 243TM ­ Check the steering head bearing play. ( Removing the fork legs 13. 26 ­ ­ Remove front wheel. x( p. [. . . ] The JASO MA Standard meets these special requirements. SAE The SAE viscosity classes were defined by the Society of Automotive Engineers and are used for classifying oils according to their viscosity. The viscosity describes only one property of oil and says nothing about quality. INDEX INDEX 120 Chassis number . 83 Compression damping fork, adjusting . 45 Compression damping, high-speed shock absorber, adjusting . [. . . ]