User manual KTM 525 XC ATV

[. . . ] OWNER'S MANUAL 2008 450 XC ATV 525 XC ATV ART. 3211251en DEAR KTM CUSTOMER 1 Congratulations on your decision to buy a KTM ATV. You are now the owner of a state-of-the-art sports ATV that will give you enormous pleasure if you service and maintain it accordingly. We wish you great pleasure riding the vehicle! Enter the serial numbers of your vehicle below. [. . . ] The operations are the same on the left and right. Mount and tighten with bushings Check parts for damage and wear. Place the A-arm with the bushings screws . Specification Screw, A-arm top Remove the vehicle from the work stand. 31) 45 Nm (33. 2 lbf ft) Toe width of rear axle The toe width can be adjusted by installed the spacing sleeve in various ways. 76 mm (2. 99 in) Difference between narrow/wide toe 100101-10 Adjusting the toe width of rear axle Warning x Danger of accidents Changes to the chassis can strongly influence how the vehicle handles. After making changes, always ride slowly to allow yourself to respond to vehicle handling. Loosen nuts of the wheel hubs on both sides. 31) on both sides and take all parts off of the rear axle. ( Remove the nuts Check parts for damage and wear. Replace damaged or worn parts. Info The left and right toe width should have the same settings. 100102-10 MAINTENANCE ON CHASSIS AND ENGINE 2 3 00 0 1 Setting a narrow toe width: Mount the wheel hub Mount the conical ring Mount the spacing sleeve . with the cone facing inward. 42 Mount the washer and the new self-locking nut. 100103-10 23 00 0 1 100104-10 Setting a wide toe width: Mount the spacing sleeve Mount the conical ring Mount the wheel hub . with the cone facing inward. with the cone facing outward. Mount the washer and the new self-locking nut. Remove the vehicle from the work stand. ( Tighten nuts Specification Nut, rear wheel hub Shift gear to neutral. 31) M18x1, 5 130 Nm (95. 9 lbf ft) 100102-10 Handlebar position The handlebar position can be adjusted 4-fold by turning the handlebar support and the handlebar support . The holes on the handlebar support are placed at a distance of from the center. Distance between holes 3. 5 mm (0. 138 in) from the center. The holes on the handlebar bridge are placed at a distance of Distance between holes 7. 5 mm (0. 295 in) 100098-10 MAINTENANCE ON CHASSIS AND ENGINE Adjusting handlebar position 43 x Pull the instrument support off the handlebar and swing it to the side. Info Protect the vehicle and its attachments from damage by covering them. Do not bend the cables and lines. 100100-10 Remove the four screws forward and set it down. Remove the nuts Remove screws Remove screws and . . Remove the handlebar clamps , swing the handlebar and remove the handlebar support . Remove the handlebar bridge . with the screws. Check parts for damage and wear. onto the steering column in the desired position. [. . . ] Whereas long service intervals are demanded for automobile engines, high performance at high engine speeds are in the foreground for motorcycle engines. With most motorcycles, the gearbox and the clutch are lubricated with the oil as the engine. The JASO MA Standard meets these special requirements. SAE The SAE viscosity classes were defined by the Society of Automotive Engineers and are used for classifying oils according to their viscosity. The viscosity describes only one property of oil and says nothing about quality. INDEX A Air filter cleaning . [. . . ]