User manual KURZWEIL PC2 MUSICIANS GUIDE REV A

[. . . ] Kurzweil PC2 Musician's Guide 2000 All rights reserved. Kurzweil is a product line of Young Chang Co. ; Kurzweil and PC2 are trademarks of Young Chang Co. All other products and brand names are trademarks or registered trademarks of their respective companies. Product features and specications are subject to change without notice. Part Number: 910345 Rev. [. . . ] Doing it this way, however, adds a lot of other features to the resulting setup, and you may not want that. Sometimes its better to start from scratch. Press the Zone 1 through Zone 4 buttons in turn. As you press each button, notice how the bottom line of the display shows you the corresponding zone number. Youll also notice that every zone already has a program assigned to it. Thats ne, because you can always mute zones (or turn then off). In fact, all the zones are muted now (their zone buttons are orange). You muted Zone 1 when you pressed its button, because it was the current zone. Lets shut two of the zones off, to make the setup as simple as possible. The display looks like this: Zone:3-||||||||0:105 MIDI|Channel:|03 4-13 Programming Your PC2 The Setup Editor The top line indicates the current zone, as well as the current bank and program ID. Notice the minus sign after the zone number, indicating that the zone is muted. Turn the Alpha Wheel to the left until you see Off in the bottom line of the display. Notice that the Zone 3 button is now unlit, indicating that the zone is off. You now have a two-zone setup (the setup still has four zones, but two of them are completely inactive). Press the Zone 1 button to make Zone 1 the current zone. Press the Program button, and you should see 000|Stereo|Grand on the bottom line of the display. If you dont, select it using your favorite data entry method. Press the Zone 2 button to make Zone 2 the current zone. Press Store to display the Save dialog: Save|Setup|129?A01|Default|Setup Notice that the PC2 suggests a setup ID of 129, which is the rst unused setup ID in the User bank. Well use that ID, but well rename the setup before storing it. Press >, and the display prompts you to rename the setup. [. . . ] This is necessary if you are upgrading the software or installing ROM options. If youre not concerned about losing all of your work, or it has been saved using a MIDI Sysex dump (see page 4-4), then press the button beneath the Yes on the display. The PC2 will execute a hard reset and start running normally. Running the Diagnostics The Run diags option executes the diagnostics that are loaded with the operating system. Some diagnostic tests will erase the PC2s memory, which will cause a hard reset when the PC2 is powered on again. [. . . ]