User manual KUSSMAUL 091-150

[. . . ] FILE: 091-150 DATE: 06-05-02 REV. INSTRUCTION MANUAL AUTO PUMP TIMER A TIMER TO LIMIT THE RUNNING TIME OF THE AUTO PUMP MODEL# 091-150 INPUT: 12VOLTS, D. C. [. . . ] Connect a 14AWG wire to the "Com" terminal of the relay on the timer. Use an un-insulated ¼" female quick disconnect. 4. Connect the other end of this wire to the open terminal on the pressure switch ­ see Figure 1. 5. Check all wiring before proceeding 6. Close the Pressure Switch assembly. 7. The yellow LED on the Model 091-150 Auto Pump Timer, when lit, indicates that the pump is in the "rest" portion of its cycle and the motor is not running. SPECIFICATION AND OUTLINE Input Power: 12VDC (from Pressure switch input to relay COM). Input Current Draw: 80 ma. with pump resting. Relay Contact Rating: 30 amps @ 14 VDC Weight: 4 ounces 5. 10 3/16" DIA. 2. 95 4, 50 1. 55 OUTLINE DRAWING Figure 2 A to P m u up A C mre s r ir o p s o Note: make sure the Auto Pump is mounted vertical. 091-150 AUTO PUMP TIMER N. C. N. O. C C h a s s is G ro u n d BLAC K -12 VOLT S C h a s s is G ro u n d RED +12 VOLT S C h a ss G ro u n Pressure Sw itch Range Nut O p tio n a l S w it c h O p tio n a l Fu se CAUTION: Observe correct polarity connections Red lead to motor and timer MUST be positive Figure 1 Installation Wiring INSTALLATION RECORD & WARRANTY Date Installed________________________________________ Installed By___________________________________________ Vehicle Identification_________________________________ Vehicle Owner________________________________________ WARRANTY All products of Kussmaul Electronics Company Inc. [. . . ] The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others. [. . . ]