User manual KUSSMAUL 091-66

[. . . ] While it is desirable to have a charger to maintain this battery in a fully charged condition, this battery is relatively lightly loaded. It is never required to operate any of the vehicle mounted accessories and is rarely discharged. The vehicle, however, may have multiple batteries which may be heavily loaded and require considerable charging. [. . . ] BATTERY SAVER & INDICATOR A 5 ampere BATTERY SAVER is built into the charger. When connected as shown in the installation wiring diagram, loads on the vehicle battery such as radios and rechargeable hand lights are automatically switched to the BATTERY SAVER when power is applied to the charger. The BATTERY SAVER allows more efficient charging by removing these loads. A BATTERY SAVER overload indicator alerts the operator that the BATTERY SAVER load has exceeded 5 amperes. WHEN A BATTERY SAVER OVERLOAD OCCURS THE BATTERY SAVER OUTPUT IS INTERRUPTED BY AN AUTOMATIC THERMAL CIRCUIT BREAKER. THIS CIRCUIT BREAKER WILL CONTINUALLY CYCLE THE OUTPUT ìONî AND ìOFFî UNTIL THE OVERLOAD IS REMOVED. WHENEVER THE BATTERY SAVER OUTPUT IS ìOFFî THE OVERLOAD INDICATOR IS LIT. Remote Dual Battery Charge Condition Indicator This remote indicator shows the charge condition of each battery in 10 levels for "LOW CHARGE" to "FULLY CHARGED". This device indicates a defective battery when a bar graph does not rise to the "FULLY CHARGED" level after an extended period of charging. NOTE: If a battery is being charged with an external load of 1. 5 to 5 amperes across its terminals, the bar graph may move down 1 or 2 levels. This does not indicate a defective battery. To avoid this, connect all external loads to the BATTERY SAVER terminals Loads connected to the BATTERY SAVER will be powered either from the BATTERY SAVER power supply when the A. C. power is "ON" or they will be connected to the vehicle battery when the A. C. power is "OFF". INSTALLATION WIRING DIAGRAM R e m o te Ind ica to r AUTO CHARGE D POWER REMOTE DISPLAY BATTERY SAVER OVER LOAD FUSE POSITIVE CM O ENGINE VEHICLE BATTERY BATTERY BATTERY SAVER C h a s sis G ro u n d + 12 Vo lts C h a s sis G ro u n d Engine Battery C h a s sis G ro u n d Battery Saver Loads (5 amps max. ). When the charger is disconnected from 120 volts AC the Battery Saver loads are automatically connected to vehicle battery. Vehicle Battery A cce ss orie s WIRE SIZE CHART CONNECTION DEFINITION WIRE SIZE IMPORTANT : Wire size is for a maximum length of 10 feet. [. . . ] are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped. Equipment is to be returned, shipping charges prepaid and will be returned, after repair, shipping charges paid. [. . . ]