User manual KUSSMAUL 091-89

[. . . ] file: 091-89-12. p65 Rev. A 10-27-2004 INSTRUCTION MANUAL AUTO CHARGE 4000 AUTOMATIC BATTERY CHARGER MODEL #091-89-12 NOTE : This charger is designed for vehicles with dual batteries and negative ground. INPUT :120 volt, 50/60 Hz, 8 amps OUTPUT: 40 AMPERES 3 YEAR WARRANTY KUSSMAUL ELECTRONICS CO. , INC. 170 CHERRY AVE. , WEST SAYVILLE, N. Y. 11796 TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826 INTRODUCTION The Auto Charge 4000 is a compact, completely automatic, dual channel battery charger designed for vehicles with a dual battery system. [. . . ] The current limiter thus eliminates the need for an ignition interlock circuit. BATTERY SAVER & INDICATOR A 5 ampere BATTERY SAVER is built into the charger. When connected as shown in the installation wiring diagram, loads on the battery such as radios and rechargeable hand lights are automatically switched to the BATTERY SAVER when power is applied to the charger. The BATTERY SAVER allows more efficient charging by removing these loads. A BATTERY SAVER overload indicator alerts the operator that the BATTERY SAVER load has exceeded 5 amperes. WHEN A BATTERY SAVER OVERLOAD OCCURS: a. Remove the loads for approximately two minutes b. Reapply the load to the BATTERY SAVER No fuses are required or provided as the BATTERY SAVER contains an automatic circuit breaker. REMOTE BATTERY CHARGE CONDITION INDICATOR This remote indicator shows the charge condition of each battery in 10 levels from "LOW CHARGE" to "FULLY CHARGED". This device indicates a defective battery when a bar graph does not rise to the "FULLY CHARGED" level after an extended period of charging. NOTE: If a battery is being discharged with an external load of 1. 5 to 6 amperes across it's terminals, the bar graph may move down 1 or 2 levels. This does not indicate a defective battery. To avoid this, connect all external loads to the BATTERY SAVER terminals. Loads connected to the BATTERY SAVER will be powered either from the BATTERY SAVER power supply when the A. C. power is "ON", or they will be connected to battery #1 when the A. C. power is "OFF". Installation Wiring Diagram Auto Charge 4000 POWER Indicator BATTERY SAVER OVERLOAD REMOTE DISPLAY 4 3 2 1 BATTERY SAVER POSITIVE COM BAT 1 BAT 2 A. C. POWER Strip insulation 15/32 so that wire strands are flush with end of eyelet, 2 places +1 2 Volt s Chassis Ground Battery Saver Loads (5 amps max. ). When the charger is disconnected from 120 volts AC the Battery Saver loads automatically are connected to battery #1. Chassis Ground Chassis Ground Accessories NOTE: Minimum wire size on charger output and ground is #8 AWG. [. . . ] Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment was shipped. shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its [. . . ]