User manual KYOCERA DP-2800 PLUS

[. . . ] Please read the instruction handbook before using the printer. Keep it close to the printer for easy reference. INSTRUCTION HANDBOOK Laser Printer The DP-2800plus in this photograph is equipped with two optional paper feeders (ST-1000) and an optional document finisher (F-8118). introduction Please read the instruction handbook before using the printer. Keep it close to the printer for easy reference. The sections of this handbook and parts of the printer marked with symbols are safety warnings meant to protect the user, other individuals and surrounding objects, and ensure correct and safe usage of the printer. The symbols and their meanings are indicated below. [. . . ] Press the CANCEL key to stop reading fonts. 3. 5. Pressing the ENTER key again will cause Processing to appear in the lower part of the message display and font data to be read from the font card. After fonts have been read, the message display will return to >Read fonts. Pressing the EXIT key will cause the message display to return to Ready. 2-42 Memory Card Reading Macros from a Memory Card Macro data on a memory card can be registered on the printer. Registered macro data can be used just like macro data located in printer memory. If a memory card already containing macro data is inserted in the printer, that macro data will be read into the printer automatically when the printer's power is turned on. The operation described here is performed when a memory card is inserted while the message display reads Ready. Note______________________________________________________________________ Macro data on a memory card has no effect on printer memory. 1. Check that the memory card containing macro data is inserted. Bring up the menu >Read macro on the message display. This display only appears if a memory card containing macro data is inserted. Press the CANCEL key to stop reading macro data. 2. 3. 5. Pressing the ENTER key again will cause Processing to appear in the lower part of the message display and macro data to be read from the memory card. After macro data has been read, the message display will return to >Read macro. Pressing the EXIT key will cause the message display to return to Ready. 2-43 Chapter 2 Operating the Page Printer Notes _____________________________________________________________________ · · If the name of a macro on the memory card is the same as that in printer memory, the macro data on the memory card with the conflicting name will not be registered. Registered macro data will be lost if the memory card is pulled out. Re-execute >Read macro if this happens. Reading Data (Partitions) from a Memory Card Specified data (partitions) on a memory card can be read into printer memory. Bring up the menu >Read data on the message display. This display only appears if there is data on the memory card. 1. 2. You can scroll through data names on the memory card one by one by pressing the + key. Press the CANCEL key to stop reading data. 4. Press the ENTER key while the desired data name is being displayed. Processing will appear in the message display and the selected data will be read into the printer. After data has been read, the message display will return to Ready. 2-44 Memory Card Writing Data (Partitions) to a Memory Card Data sent from the computer can be written on a memory card. Data written on the card can be read into printer memory by key operations from the control panel of the printer. [. . . ] You can select either of two Courier fonts, Dark (bold) or Light (thin), as the default font. The selection made applies to both bit map fonts and scalable fonts; the two cannot be set independently. The >Size menu is not available for the Courier and Letter-Gothic fonts. The >Pitch menu is displayed instead for these fixed width fonts. (*3) *3: Page set Page orientation Portrait Landscape Opt. [. . . ]