User manual KYOCERA F-4730

[. . . ] ALWAYS read this Operation Guide thoroughly before use. After reading, maintain it in good condition and keep it together with the Instruction Handbook for your copier. ALWAYS read this Operation Guide thoroughly before use. After reading, maintain it in good condition and keep it together with the Instruction Handbook for your copier. [. . . ] Remove all of the finished copies from the Non-sort tray and then resume copying. * When the Hole Punch mode is used in combination with either the Sort, Sort-Staple or Group mode, the finished copies will be ejected face down onto the Sort tray regardless of where the originals are set. Select the desired paper size and copy exposure, etc. * The copy paper sizes that are acceptable for hole-punching and the available positioning and number of holes may differ depending on the specifications for your unit. 4 hole punch: A3, A4 (45 g/m2 - 160 g/m2 weight plain paper) * Hole punching is not available with A5R size paper when the originals are set in the Document Feeder. Remove all of the finished copies from the Non-sort tray. The finished copies will be ejected face down onto the Non-sort tray. * If the originals to be copied are set on the platen, the finished copies will be ejected face up onto the Sort tray. * If the number of A3 (11" x 17") or B4 (81/2" x 14") size copies to be made is set to 151 or more ­ or to 251 or more for A4 (11" x 81/2") or A4R (81/2" x 11") size copies ­, the Stacking mode will engage and the finished copies will be ejected onto the Sort tray. * If you are using a 62 ppm copier, the first 99 copies will be ejected onto the Non-sort tray and any copies from 100 onward will all ejected onto the Sort tray. * If the Stacking mode does not engage and the number of finished copies in the Non-sort tray reaches the acceptable limit, an error message will be displayed on the copier and copying will stop. Remove all of the finished copies from the Non-sort tray and then resume copying. Remove all of the finished copies from the Non-sort or the Sort tray, as appropriate. Select the Interrupt copy mode on the operation panel of your copier and perform the appropriate procedure to start copying. * Refer to the Instruction Handbook of your copier for more detailed information on the Interrupt copy mode. * If the present copy job is being ejected onto the Sort tray, the copies made in the Interrupt copy mode will be ejected on the Non-sort tray. If the present copy job is being ejected onto the Non-sort tray, the new copies will be ejected on the Sort tray. Replace the present original(s) with the one(s) to be copied. Select the desired paper size and number of copies to made, etc. Copying will begin and the finished copies will be ejected onto the Sort tray or Non-sort tray. After Interrupt copying is completed, perform the required operation on your copier to release the Interrupt copy mode. The copy job that was interrupted will then resume. [. . . ] * Once the internal tray is pulled out, DO NOT attempt to move the internal tray guide A. If this guide is moved, there is a danger of damage to the Finisher. If there is any jammed paper in the internal tray, remove it without tearing it. Replace the internal tray in its original position all the way into the Finisher. [. . . ]