User manual KYOCERA FS-1010

[. . . ] Table of Contents Page Printer Operation Guide Caution NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. Notice on Software SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION MODE. The printer is factory-set to emulate the PCL. The emulation mode can be changed by following the procedures described in Chapter 1 . Notice The information in this manual is subject to change without notification. Additional pages may be inserted in future editions. [. . . ] Press the key to print data as far as it was stored. To release the page protect mode, send the following command to the printer from the KM-NET for Clients after this error occurs: !R!FRPO R5, 1; EXIT; KPDL Error Press GO MemoryCard err## Press GO Memory overflow Press GO Print overrun Press GO RAM DISK error ## Press GO Check the error code displayed in ## and refer to the appropriate description below. Expand printer memory. (Continued on next page) 3-11 Indicators Indicator KM-NET for Clients display Memory card err20 Corrective Action The printer has halted because you attempted to insert/ remove a memory card into/from the printer slot while the printer power is on. Turn the power switch off and then on to restart the printer. Make sure to turn the printer power off before inserting/ removing a memory card. (No indication patterns available) Format error Memory card This message appears when the printer is in the ready state and the memory card is not formatted, and therefore cannot be read or written. Format the memory card. 3-12 Indicators 3. 3. 4 Normal Indicator Display The following displays appear during normal printer operation. Indicator KM-NET for Clients display Cancelling data Description Data inside the printer is being canceled. The indicators light in sequence from the top, then go off in sequence from the bottom. When the printer is switched on for the first time after the toner container is installed, (Adding toner) also appears. The printer is warming up and is not ready to print. The indicators light in sequence twice from top to bottom. When the printer is switched on for the first time after the toner container is installed, (Adding toner) also appears. Please wait Processing The printer is receiving data. Processing Waiting The printer is processing data. The printer is waiting for the end-of-job command before printing the last page. Pressing the key allows you to obtain the last page immediately. The printer is printing the last page after a waiting period. The printer is ready to print. Form Feed Timeout Ready The printer is offline. The printer stores but does not print received data. The indicator flashes at 5-second intervals and all other indicators go off. The printer wakes from Sleep mode whenever a key on the operator panel is pressed, the cover is opened or closed, or data is received. The printer then warms up and goes online. (You can set the amount of time before the printer enters sleep mode from the KM-NET for Clients utility. ) 3-13 Correcting a Paper Jam 3. 4 Correcting a Paper Jam This section describes how to remove paper when it jams in the printer. The printer will stop whenever paper jams in the printer or paper is not fed from a paper cassette. [. . . ] You can view information for printers connected to the network using SNMP commands. KM-NET VIEWER is contained on the Kyocera Mita Software Library CD-ROM supplied with the printer. Face-up tray This is located at the rear of the printer. Select paper output to the face-up tray when printing on postcards, envelopes, or labels. KPDL (Kyocera Printer Description Language) This is Kyocera Mita's version of Adobe PostScript 2. First mode This is an operation mode for the MP tray. Because the MP tray default setting is set to first mode (priority printing from the MP tray), if there is paper inserted in the MP tray, the first Glossary-2 Glossary MB (mega byte) This unit is used to express data quantities and memory capacities. [. . . ]