User manual KYOCERA FS-1020D

[. . . ] FS-1020D Page Printer Operation Guide Caution NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. Notice on Software SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION MODE. The printer is factory-set to emulate the PCL. The emulation mode can be changed by following the procedures described in Chapter 1 . Notice The information in this manual is subject to change without notification. Additional pages may be inserted in future editions. [. . . ] You can abandon printing by pressing the key. An error has occurred during access to the memory card using the PRESCRIBE RWER command or from the KMNET for Clients. Look at the error code given in place of ## and refer to the corresponding description given below. 04 :The capacity of the memory card is insufficient. You can abandon printing by pressing the key. Printing cannot continue because there is not enough memory. You can abandon printing by pressing the key. Current print processing cannot continue due to complex data. The data transferred to the printer was too complex to print on a page. Press the key to print data as far as it was stored. To release the page protect mode, send the following command to the printer from the KM-NET for Clients after this error occurs: !R!FRPO R5, 1; EXIT; KPDL Error Press GO MemoryCard err## Press GO Memory overflow Press GO Print overrun Press GO Note RAM DISK error ## Press GO Check the error code displayed in ## and refer to the appropriate description below. Expand printer memory. Table 3-5 3-12 Indicators Indicator KM-NET for Clients display None Corrective Action The printer has halted because you attempted to insert/ remove a memory card into/from the printer slot while the printer power is on. Turn the power switch off and then on to restart the printer. Make sure to turn the printer power off before inserting/ removing a memory card. Note None Format error Memory card This message appears when the printer is in the ready state and the memory card is not formatted, and therefore cannot be read or written. Format the memory card. Table 3-5 (Continued) 3-13 Indicators 3. 3. 4 Normal Indicator Display The following displays appear during normal printer operation. Indicator KM-NET for Clients display Cancelling data Description Data inside the printer is being canceled. The indicators light in sequence from the top, then go off in sequence from the bottom. When the printer is switched on for the first time after the toner container is installed, (Adding toner) also appears. The printer is warming up and is not ready to print. The indicators light in sequence twice from top to bottom. When the printer is switched on for the first time after the toner container is installed, (Adding toner) also appears. Please wait Processing The printer is receiving data. Processing Waiting The printer is processing data. The printer is waiting for the end-of-job command before printing the last page. [. . . ] The printer has one expansion slot, and you can install a 8 MB, 16 MB, 32 MB, 64 MB, 128 MB, or 256 MB DIMM (Dual Inline Memory Module). Contact your Kyocera Mita dealer to purchase the DIMM that is best suited for use with this printer. KPDL (Kyocera Printer Description Language) This is Kyocera Mita's version of Adobe PostScript 3. First mode This is an operation mode for the MP tray. Because the MP tray default setting is set to first mode (priority printing from the MP tray), if there is paper inserted in the MP tray, the first paper will always feed from there even if another paper source is selected. First mode is specified as the factory default, but you can change this setting from the KM-NET for Clients. MB (mega byte) This unit is used to express data quantities and memory capacities. [. . . ]