User manual KYOCERA FS-1050

[. . . ] Table of Contents Page Printer Operation Guide Caution NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. Notice on Software SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION MODE. The printer is factory-set to emulate the PCL. The emulation mode can be changed by following the procedures described in Chapter 1. Notice The information in this manual is subject to change without notification. Additional pages may be inserted in future editions. [. . . ] The display cycles through the available selections in the following order (The key cycles in the reverse order): >MSG Language ?Português If you want to abandon this procedure, press the CANCEL key. 7 8 Press the ENTER key. The message display returns to Ready. 1-77 Using the Operator Panel Automatic Form Feed Time-out Setting When the printer remains idle for some time, it times out and releases the current interface; it prints whatever data is in its buffer and feeds out the page. You can adjust the time-out length as follows: 1 2 Press the MENU key. Press the or key until Others > appears. Others > 3 4 Press the > key. Press the or key until >Form Feed Time Out appears. The default is 30 seconds. >Form Feed Time Out 030sec. 5 6 Press the ENTER key. A blinking cursor (_) appears. >Form Feed Time Out 030sec. Press the or key to increase or decrease the value where the cursor is blinking and so set the desired time. The time can be set between 0 and 495 seconds, in 5-second increments. You can use the > and < keys to move the cursor right and left. If you want to abandon this procedure, press the CANCEL key. 7 8 Display the desired time and press the ENTER key. The message display returns to Ready. 1-78 Using the Operator Panel Sleep Timer Setting The printer has a sleep timer that allows to conserve power when it is not printing, processing or receiving data. You can adjust the timer; in other words, you can set the length of time before the printer enters sleep mode when it is idle. The default is 5 minutes. 1 2 Press the MENU key. Press the or key until Others > appears. Others > 3 4 Press the > key. Press the or key until >Sleep Timer > appears. The default setting is 005 min. >Sleep Timer > 005 min. 5 Press the ENTER key. A blinking cursor (_) appears. >Sleep Timer 005 min. 6 Press the or key to increase or decrease the value where the cursor is blinking and set the desired time. The timer can be set between 5 and 240 min. , in 5-minute increments. You can use the > and < keys to move the cursor right and left. If you want to abandon this procedure, press the CANCEL key. 7 8 Press the ENTER key. The message display returns to Ready. 1-79 Using the Operator Panel Turning Off the Sleep Timer You can turn off the sleep timer function by following the procedure given below. 1 2 3 4 5 6 7 Press the MENU key. [. . . ] Contact your Kyocera Mita dealer to purchase the DIMM that is best suited for use with this printer. KPDL (Kyocera Printer Description Language) This is Kyocera Mita's version of Adobe PostScript 2. Face-up tray This is located at the rear of the printer. Select paper output to the face-up tray when printing on postcards, envelopes, or labels. Kyocera Mita Digital Library This is the CD-ROM supplied with the printer. The contents of the CD-ROM include manuals, printer drivers, and various utilities. First mode This is an operation mode for the MP tray. When the MP tray setting is set to first mode (priority printing from the MP tray) with paper inserted in the MP tray, the first paper will always feed from MB (mega byte) This unit is used to express data quantities and memory capacities. [. . . ]