User manual KYOCERA FS-1700

[. . . ] Table of Contents r Français r Italiano FS-1700/3700 Users Manual Kyocera Laser Printers Introduction Caution NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION MODE. The printer is factory -set to emulate the HP LaserJet 4 Plus. The emulation mode can be changed by following the procedures described in Chapter 2 (on CD-ROM). [. . . ] When the formatting operation is successfully completed, the printer automatically prints out a formatting information page as shown below. Card size. The total size of the memory card memory in bytes. The size the printer uses for its system in bytes. The size remaining in the memory card for storing data in bytes. 2-23 2. 10. Operating a Memory Card Printing a list of data names The printer prints a list of all data names (referred to as partitions) stored in a memory card for reference. (Printing a list is also available for a font card. ) The printout (example above) includes the following information. Partition (data) number. The destination name of the written data as assigned automatically by the printer. The type of the written data i. e. , whether it is host data (Data) or font data (Font). The total capacity of the memory card in bytes. The total size of the data stored in the memory card in bytes. The size of the capacity remaining in the memory card for storing further data, including the amount of memory that the printer uses for its system (approximately 70 bytes). The PRESCRIBE II command that terminates a writing operation when writing to memory card using the PRESCRIBE II ICCD command; usually WRED. 2-24 3. 1. Bitmap and Scalable Fonts Chapter 3 Fonts This chapter describes the types of fonts you can use with the printer, including the printer's resident and KPDL fonts (option), and symbol sets. 3. 1. Bitmap and Scalable Fonts A font is a set of characters of a particular design. The design is referred to as a typeface. Several characteristics identify a font. These include the font type (bit map or scalable), symbol set, spacing, pitch, height, style, stroke weight, and typeface family. The printer provides two types of resident fonts: bitmap fonts and scalable (outline) fonts . Also, fonts may be downloaded to the printer's memory from a memory card or disk. These fonts are referred to as downloadable or soft fonts. The printer accepts as many downloadable fonts as its user available memory permits. 3-1 3. 1. Bitmap and Scalable Fonts Bitmap fonts A bitmap font is made of a fixed bit pattern (Figure 3. 1. ). [. . . ] Check that the solder connections are secure. Desolder wires 2 and 3, then resolder them in crossed configuration. Solder wire 2 to pin 3 and wire 3 to pin 2. Cover the solder joints with thermofit tube. [. . . ]