User manual KYOCERA FS-1750

[. . . ] Table of Contents FS-1750 FS-3750 User's Manual Kyocera Laser Printer Introduction Caution NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. Notice on Software SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION MODE. The printer is factory-set to emulate the PCL 6. The emulation mode can be changed by following the procedures described in Chapter 2. Notice The information in this manual is subject to change without notification. Additional pages may be inserted in future editions. [. . . ] Press the + or ­ key and selectý5$0ý', 6. ýPRGHý!. Pressing the ENTER key will cause aý" to flash. Press the + or ­ keys to displayý2Q and then press the ENTER key. 4. Press the key to displayý!5$0ý', 6. ýVL]H. Press the ENTER key again, and change the RAM DISK size using the + or ­key. It is not possible to make a setting that exceeds total printer memory. The default value for the RAM DISK is the total printer memory minus 9 MB. This parameter may be set anywhere fromýíì toýçê depending on the available printer memory. Press the EXIT key if you want to cancel the setting. 6. Once the desired RAM DISK size is displayed, press the ENTER key. Then turn the printer's power off and on again. The setting will be activated after restart. RAM DISK Operations The following operations are available with the RAM DISK. Ì Ì Ì Ì Read Data Write Data Delete Data Print a List of Data Names Procedures for all operations are the same as for a memory card. Please see the memory card item for the given procedure. 2-14 2. 6. Operating a Memory Card 2. 6. Operating a Memory Card Hints on Writing Fonts to the Memory Card Some memory card writer utility programs are available for writing data to the memory card. If you write fonts into a memory card, we recommend you write them as font data and not as host data. Fonts written in a memory card as font data are automatically loaded in the printer when it is switched on and are usable on all the printer interfaces simultaneously. The printer reads only the header part of these fonts into its memory and therefore these fonts do not occupy a large area in the printer's memory. If you write the fonts in the memory card as host data, the fonts are transferred directly from the memory card into the printer's memory when the card is read. This may require extra memory to be installed in the printer as they usually occupy a great amount of the printer's memory. Moreover, use of the fonts is restricted on only the interface that was active during the fonts were read from the memory card. To properly write font data into the memory card, refer to the memory card writer manufacture's instructions. Reading Fonts/Data from a Memory Card If the memory card is already inserted in the slot when the printer is powered on, the fonts are automatically read into the printer. [. . . ] If this is set toý2Q, error data will be printed if trouble occurs during printing. This is set toý2II before leaving the factory. *3: You can select either Courier or Letter Gothic. Any font can be selected asý'DUN orý5HJXODU. [. . . ]