User manual KYOCERA FS-1900

[. . . ] Table of Contents FS-1900 Page Printer Operation Guide Caution on Installation NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. Notice on Software SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION MODE. The printer is factory-set to emulate the PCL. The emulation mode can be changed by following the procedures described in Chapter 1. Notice on This Guide The information in this guide is subject to change without notification. Additional pages may be inserted in future editions. [. . . ] Press the or key repeatedly until Life Counters > appears. Life Counters > Press the > key. Press the appears or key repeatedly until >New Toner Installed. >New Toner Installed 1-96 Configuration 5 6 Message Language Press the ENTER key. A question mark (?) appears. >New Toner Installed ? Press the ENTER key. The message display returns to Ready. You can select the language of the messages on the message display by following the procedure given below. You can optionally download messages in order language. Contact your Kyocera Mita dealer for information. 1 2 3 4 Press the MENU key. Press the or key repeatedly until Others > appears. Others > Press the > key. Press the or key repeatedly until >MSG Language appears. The default message language is English. >MSG Language English 5 To change the language, press the ENTER key. A blinking question mark (?) appears. >MSG Language ?English 1-97 Configuration 6 Press the key. The display cycles through the available selections in the following order (The key cycles in the reverse order): >MSG Language ?Español 7 8 Press the ENTER key. The message display returns to Ready. 1-98 Configuration Automatic Form Feed Timeout When the printer receives no data for a certain time, it time out and releases the current interface: it prints whatever data it has in its buffer and feeds out the page. You can adjust the time-out time as follows: 1 2 3 4 Press the MENU key. Press the or key repeatedly until Others > appears. Others > Press the > key. Press the or key repeatedly until >Form Feed Time appears. The default setting is 30 seconds. >Form Feed Time Out 030sec. 5 6 7 8 Press the ENTER key. A blinking cursor ( ) appears. >Form Feed Time. Time Out 030sec. Press the or key to increase or decrease the value of the figure where the cursor is blinking and set the desired time. The time can be set between 0 and 495 seconds, in 5-second increments. You can use the > and < keys to move the cursor right and left. [. . . ] A maximum of 255 virtual mailboxes can be set up, making it possible to allocate documents not just for individual departments or groups, but even for individual people. The print jobs will not be deleted when the printer is turned off. Before Using Virtual Mailboxes To use the virtual mailbox function, select PCL XL or PCL 5e emulation and then set the Mailbox Name and Virtual Output Tray beforehand. Follow these procedures. 1 2 3 Browse through Windows Start > Settings > Printers. [. . . ]