User manual KYOCERA FS-3700+

[. . . ] Table of Contents FS-1700 FS-3700 User's Manual Kyocera Laser Printer Introduction Caution NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION MODE. The printer is factory-set to emulate the HP LaserJet 5M (excluding support for paper sizes larger than A4/letter). The emulation mode can be changed by following the procedures described in Chapter 2. [. . . ] Opening and closing the printer's top cover or drawing out and closing the current paper cassette also awakens the printer to start warming up and become ready. The printer also enters into sleeping mode if it times out while MODE SELECTing, or requesting the addition of paper or toner, indicating the appropriate maintenance message on its message display. 2-14 2. 5. KIR Level This printer incorporates the KIR 2 (Kyocera Image Refinement 2) smoothing function. KIR 2 provides high quality printing by providing a software-type improvement to the resolution. Q The KIR setting is . The KIR setting is . Set the print density to when setting the KIR 2 mode. For details on print density, see page 2-17. You can look at the check line, the last line on a status page, to make the optimum KIR 2 mode setting. Status Page KIR Checking Lines 2-15 2. 6. Ecoprint mode Optimized stripes The current KIR setting is optimal. Dark vertical stripes Set the KIR mode to 2II. If you still get dark vertical stripes, adjust the print density control to a lighter setting. (See the last page in this manual. ) White vertical stripes Set the KIR mode to 2Q. If you still get white vertical stripes, adjust the print density control to a darker setting. (See the last page in this manual. ) 2. 6. Ecoprint mode The Ecoprint enables you to reduce the amount of toner consumed on the page so as to save your printing costs. You can set to Ecoprint mode on, as follows. ) The Ecoprint mode setting is 2Q when the printing image becomes lighter, yet very readable. The Ecoprint setting has no effect on the print speed. Ecoprint setting is 2II (default). Ecoprint setting is 2Q. 2-16 2. 7. Resource Protection When you switch from the HP LaserJet emulation to another, all downloaded fonts and macros are lost. Resource protection preserves these PCL resources in memory so that they are intact when you change the emulation back to HP LaserJet 5M. By using the printer's MODE SELECT, you can select from two resource protection modes as follows:  In this mode, the printer stores fonts, macros, symbol sets, etc. in memory that were downloaded as permanent PCL resources. All temporary resources are lost when the emulation mode is changed from HP LaserJet 5M to another or vice versa.  In this mode, the printer stores both permanent and temporary resources when the emulation mode is changed from HP LaserJet 5M to another or vice versa. Resource protection requires extra memory to store the downloaded fonts and macros. The total size of the printer memory recommended for using the resource protection option is affected by several factors. Adjusting the Print Density If necessary, the print density can be adjusted from the MODE SELECT MENU. [. . . ] Press the + or - key repeatedly until the message display indicates the desired item. Press the ENTER key to start changing the setting. Press the + or - key until the desired setting is selected. If you want to abandon the setting, press the CANCEL key instead of the ENTER key. [. . . ]