User manual KYOCERA FS-5900C

[. . . ] Thank you for purchasing the Kyocera FS-5900C Colour Laser Printer. Notice NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. The information in this manual is subject to change without notification. Additional pages may be inserted in future editions. The user is asked to excuse any technical inaccuracies or typographical errors in the present edition. [. . . ] Press the + key repeatedly until the message display indicates Others>. Press the key. Press the + key repeatedly until the message display indicates >Sleep timer. The current sleep timer (in minutes) is indicated. Press the ENTER key. Press the + or - key to change the timer setting. You can use the key to quickly change the timer setting. Press the ENTER key to finalize the setting. Press the MODE key to exit the mode selection menu. or Once the set time arrives, the printer will display Sleeping and all indicators will go out. This minimizes the amount of energy used. Resource Protection When you switch from the PCL 5C emulation to KPDL, all downloaded fonts and macros are lost. Resource protection preserves these PCL resources in memory so that they are intact when you change the emulation back to PCL 5C. By using the printer's >Resource prot. menu, you can select from two resource protection modes: 62 Using the Printer Permanent In this mode, the printer stores fonts, macros, symbol sets, etc. in memory that were downloaded as permanent PCL resources. All temporary resources are lost when the emulation mode is changed from PCL 5C to KPDL or vice versa. Permanent and temporary In this mode, the printer stores both permanent and temporary resources when the emulation mode is changed from PCL 5C to another or vice versa. To select the resource protection mode: 1 2 3 4 Press the MODE key on the printer panel. Press the + key repeatedly until the message display indicates Others>. Press the key. Press the + key repeatedly until the message display indicates >Resource prot. The current resource protection mode is indicated -- Permanent or Perm/Temp. >Resource prot. Perm / Temp 5 6 7 8 Press the ENTER key. The question mark (?) will appear blinking. Press the + key to change from Permanent to Perm/Temp, or vice versa. Press the ENTER key to finalize the setting. Press the MODE key to exit the mode selection menu. 63 Care and Maintenance Cleaning Periodic cleaning of the printer is recommended. The frequency of cleaning is dependent upon the environment in which the printer is used. You should clean the printer: · At least once a month. · When the printer experiences frequent media jams. [. . . ] 92 Printer driver . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 Printer driver for Windows 3. 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27, 28 Printer driver for Windows 95/Windows 98 . . . . . . . . . . . . . . . 28 Printer panel message . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]