User manual KYOCERA FS-680

[. . . ] Kyocera EcoLAN 3000E User's Manual Network Connectivity for Kyocera Printers Preface Thank You Thank you for choosing the award winning Kyocera network printing products. We are sure you will appreciate the high performance and low cost of ownership that are the hallmarks of Kyocera products. Copyright Notice © 1998, Kyocera Corporation, All Rights Reserved. Trademarks Kyocera® is a registered trademark of Kyocera Corporation. Novell® and NetWare® are registered trademarks of Novell, Incorporated. Microsoft® and Windows® are registered trademarks of Microsoft Corporation. [. . . ] If either Microsoft TCP/IP Printing or Simple TCP/IP Services is not in the list of Network Services, click on Add to install them. Click on Close when all protocols and services have been added. If the TCP/IP protocol has just been added, Windows will prompt for the IP address and other TCP/IP parameters. The new protocols and services will not be available until the system is restarted. Assigning the EcoLAN 3000E IP Address The 3000E must be configured for TCP/IP communication. Please refer to section 5. 7 for instructions. 5. 7 EcoLAN 3000E TCP/IP Configuration from Windows Windows Configuration 5-17 Configuring the Printer Driver for LPR Printing The printer driver should be installed from the CD which is shipped with the printer. Unfortunately, Windows does not make the Add LPR Port available to the Install Wizard on the CD. Therefore, the printer driver should be installed selecting a standard port such as LPT1. Once the driver installation is completed, the driver port setting should be modified for LPR printing using the following procedure. In the following instructions, some field or dialog names may vary depending upon the NT service pack in use. Click on the Windows Start button and select Settings, and then Printers. Right click on the appropriate printer and select Properties. Double click on LPR Port in the list of available printer ports. In the Name or address of server providing lpd: field, enter the IP address of the 3000E or the 3000E NetBIOS name (see the WINS Configuration section for more information on using the NetBIOS name). In the Name of printer or print queue on that server: field, enter any desired port name, e. g. Click on Close to close the Printer Ports dialog. The 3000E IP address is now displayed and currently selected on the list of ports. If the printer is to be shared, click on the Sharing tab, select Shared and enter the Share name. Click on OK when finished. 5. 6. 4 Windows NT 4. 0 Shared Access Printing 5. 1. 1 Windows Shared Access Printing Overview Setting a Printer as Shared in Windows NT 4. 0 This section covers the steps for a Windows NT 4. 0 machine to set a printer as shared so that other Windows users may access it. Click on the Windows Start button, select Settings, and Printers. Right click on the icon of the printer you want to share and select Sharing. On the Sharing tab, click on Shared As and enter the Share name. [. . . ] Did you select the correct printer driver in Chooser?You must first select the printer icon and then select the printer name. If you renamed the printer in the AppleTalk KYOManage for Macintosh Program, did you reselect the printer under its new name?If you placed the printer in a new zone, did you reselect the zone? [. . . ]