User manual KYOCERA FS-800

[. . . ] User's Manual Kyocera Laser Printer FS-800 Introduction Caution NO LIABILITY IS ASSUMED FOR ANY DAMAGE CAUSED BY IMPROPER INSTALLATION. SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S EMULATION MODE. The printer is factory-set to emulate the HP LaserJet 5Si (excluding support for paper size larger than A4/letter). The emulation mode can be changed by following the procedures described in Chapter 2. Notice on Software ______________________________________________________________ SOFTWARE USED WITH THIS PRINTER MUST SUPPORT THE PRINTER'S NATIVE MODE OR ONE OF ITS EMULATION MODES. Notice _____________________________________________________________________ The information in this manual is subject to change without notification. [. . . ] This may result in a paper jam or damage to the printer. Do not open covers on the printer or open the paper feed cassette during printing. Do not move the printer during printing. Refrain from frequently plugging and unplugging the power plug from the power outlet even when power is turned off. Do not plug or unplug the power cord or printer cables while the printer's power is turned on. Be sure to carefully attach and detach paper feed cassette and carefully open and close the top cover. Be sure to unplug the power cord from the power outlet and take precautions against dust gathering on the printer by draping a cover over it when it is not in use. 2-9 Operating Procedures Switching Power On Check that the power cord is securely plugged in at both ends. Check that the printer is connected to the computer (See page 1-21). Push the power switch to the ON ( | ) position. During warm-up the message display indicates Self test. At the end of the warm-up period, the ON LINE indicator lights, and the message display indicates Ready. The printer is now ready to print. Note _____________________________________________________________________ If an error is detected while the printer is warming up, the ATTENTION indicator will light. A message concerning the error will be displayed in the message display. (See Chapter 5. ) 2-10 Chapter 2 Operating the Page Printer Basic Printing Operations The flow of basic operations to print is given below. Keys on the control panel are explained after that. For details on using the MODE key, be sure to read the section "Mode Select Menu" at the end of this manual in conjunction with this section. Use the MODE key to set an emulation for the printer which conforms to the software being used. This printer is shipped from the factory with emulation set to HP LaserJet 5Si. Use the MODE key to select the font to use and paper direction. Use the MODE key to select paper feeding from the cassette or the manual feed tray. Use the MODE key to set the number of printed copies. Check that the message Ready appears in the message display and that the ON LINE indicator lights, then make preparations to print from the computer. Press the FORM FEED key if, after printing, the message Waiting appears in the message display. 2-11 Operating Procedures Canceling Printing Perform the following procedure when you wish to cancel printing after it has begun. Check if the message Processing is displayed in the message display. [. . . ] Emulation HP LaserJet 5Si Basic Operations During Mode Selection This diagram gives quick reference to all menu options and their sequence of selection. Use this description in combination with Chapter 2 Mode Selection Menu. 1. 2. lar Press the MODE key to enter Mode Selction mode. Press the + or ­ key repeatedly until the message display indicates the desired item. Font Bitmap Scalable > > >Bitmap font 00001 >AudreyTwo-Regu SWC >Size 012. 00 point (s) >Pitch 10. 00 cpi 3. [. . . ]