User manual KYOCERA FS-9520DN

[. . . ] FS-9120DN FS-9520DN Page Printer Please read the Operation Guide before using the printer. Keep it close to the printer for easy reference. The sections of this guide and parts of the printer marked with symbols are safety warnings meant to protect the user, other individuals and surrounding objects, and ensure correct and safe usage of the printer. The symbols and their meanings are indicated below. [. . . ] The factory setting is 03. >EcoPrint Mode ?Off 1 or key. Press the MENU key. 6 7 8 Select On or Off using the 2 Press the or key repeatedly until Print Quality > appears. Press the ENTER key. Print Quality > Press the MENU key. The message display returns to Ready. 3 4 Press the key. Resolution You can set the default print resolution in three ways: 300 dpi, 600 dpi and Fast 1200 mode. The clarity of printed characters and graphics becomes sharper in this order. (The factory setting is Fast 1200 mode. ) Press the or Density appears. key repeatedly until >Print >Print Density 03 1 2 Press the MENU key. Press the or key repeatedly until Print Quality > appears. 5 Press the ENTER key. A blinking question mark (?) appears. >Print Density Print Quality > ?03 3 4 Press the key. 6 key repeatedly until Select the print density from five steps from 01 (light) to 05 (dark) using the or key. Press the ENTER key. Press the or >Resolution appears. 7 8 >Resolution Fast 1200 mode Press the MENU key. The message display returns to Ready. 2. 2. 9 Operating an Option Hard Disk By installing the option hard disk into the printer, the e-MPS function can be used. The printer's menu selection system allows you to perform the following operations on the hard disk. If the option hard disk is not formatted, the >Format menu will automatically appear on the message display. · · · · Reading data Writing data Deleting data Printing of list of partitions 5 Press the ENTER key. A blinking question mark (?) appears. >Resolution ?Fast 1200 mode 6 7 8 Select Fast 1200 mode or 300 dpi, 600 dpi using the or key. Press the ENTER key. Reading Data Press the MENU key. To read data on a hard disk, proceed as follows. 1 3-32 Press the MENU key. Chapter 3 Using the Operator Panel 2 Press the appears. or key repeatedly until Hard Disk > 5 Press the ENTER key. A question mark (?) appears. >Write Data ?Hard Disk > 3 4 Press the key. 6 7 Press the ENTER key. In this state, send the file from the computer to the printer. The file is written onto the hard disk and given a destination name (also referred to as a partition name) which the printer automatically assigns one after another as follows: DataH001 (first data), DataH002 (second data), DataH003 (third data). . . In the example above, if the file TEST. TXT is the first data to be written onto the hard disk, the destination name will be DataH001. Press the or key repeatedly until >Read Data appears. [. . . ] 1 MB is equivalent to 1024 kB, or 1, 048, 576 bytes. MP tray This is an abbreviation for Multi-Purpose tray. The MP tray is used instead of the cassette when printing on envelopes, postcards, transparency sheets, and labels. Offline The printer can receive data, but cannot print. [. . . ]