User manual KYOCERA KM-4230

[. . . ] INSTRUCTION HANDBOOK Please read the instruction handbook before using the copier. Keep it close to the copier for easy reference. As an ENERGY STAR Partner, KYOCERA MITA CORPORATION has determined that this product meets the ENERGY STAR guidelines for energy efficiency. The ENERGY STAR program is an energy reduction plan introduced by the United States Environmental Protection Agency in response to environmental issues and for the purpose of advancing the development and utilization of more energy efficient office equipment. registered mark. The Auto-Shut-off time setting becomes 15 to 120 minutes in the areas corresponding to the Swiss Energy 2000 program. <Attention> This instruction handbook is for the KM-4230 (42 ppm) and KM-5230 (52 ppm). [. . . ] Copiers are generally in the standby mode longer time than in copying operation, and power consumption in the standby mode occupies the large part of the consumption. Automatic turning OFF of the copier reduces unnecessary power consumption in the standby mode and at night where the copier is left on, resulting in reduction in power rate. * For the change of time until the auto shut off function, see the "8 AUTO SHUT-OFF TIME" on page 79, and to cancel the auto shut-off function, see the "0 AUTO SHUTOFF" on page 80. * If the auto shut-off function operates when the week timer (page 67) is set or an optional I/F kit is equipped, the machine will be in the rest state leaving the main switch ON ( | ). Press the energy saver key to perform copying. 48 APPLICABLE COPY MODES (1) Reserving another copy while copying is performed [Add Job] While copying is performed, another copying can be reserved. Also, the reserved jobs and the order of the copying can be changed. * When this copy mode is used, the optional memory copy board is required. q Introduction of the add job screen 1 Job number key: The serial number is assigned until 99 in the order of registration. Even when the order is altered and the job is cleared, no number is changed. Copying operation is carried out from the job displayed in the upper part. 4 The job reservation time is displayed. 5 Residual memory: The data volume of originals stored in memory is displayed. * The form overlay mode cannot be used in the add job function. 1 Add job 1. If the message "ADDITION OF JOB IS POSSIBLE. " is displayed, the job can be reserved. * To stop job reservation, touch the "END" or "BACK" key. 2. Referring to page 19 and subsequent pages, set the function to be reserved and press the Start key. The originals will be started to be read. After all the original has been read, the touch panel will return to the step 2 screen. Copying will begin in the order of reservation when the copying of previously reserved job is completed. 49 APPLICABLE COPY MODES 2 Changing the setting contents of the add job The setting of finishing for the reserved job (number of copies and sorter mode) can be changed. When changing the number of copies, touch the "+" key or "-" key for setting. * Change the setting of finishing. Press the "SORT" key to select the mode. * If an optional finisher has been installed, the staple sort mode and the punch mode can be adjusted. When using the booklet stitcher, the staple sort mode can be adjusted. 5. [. . . ] Push the duplex unit back in all the way. Close the front cover. 102 ABOUT 52 PPM COPIER q Specifications Specifications described on page 98 are different as follows. Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Console Original table . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Fixed type Copying system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Indirect electrostatic Originals. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Platen: Sheets of paper, and books, 3-dimensional (Maximum originals size: A3) DF: Sheets of paper (A3 to A5 (vertical), one-sided original: 35 g/m2 to 160 g/m2, duplex original: 50 g/m2 to 120 g/m2) Copy sizes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A3, B4 (257 x 364 mm), A4, A5 (vertical), A6, Folio For duplex copies: A3 to A5 (vertical) Print margin loss: 0. 5-5. 5 mm Copying speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Same-size copying/memory copying; A3: 26 copies/min. , B4: 31 copies/min. , A4 (horizontal): 52 copies/min. , A4 (vertical): 35 copies/min. Warm-up time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Within 180 secs. (at room temperature of 20°C, humidity 65%RH), From energy saver mode: Within 30 secs. [. . . ]