User manual KYOCERA KM-5530

[. . . ] 4530/5530 Operation Guide Please read the Operation Guide before using the copier. Keep it close to the copier for easy reference. Off Mode The device automatically enters "Off Mode" when 90 minutes have passed since the device was last used. The amount of time of no activity that must pass before "Off Mode" is activated may be lengthened. For more information see "Auto shut-off function". [. . . ] set direction Edit Metric specifications Ready to register document(s). Set original. Press Start key. Form registration Shared Data Box Job Job001 Auto size Select regi. size Change name Basic Auto Select size orig. 1-sided Original type 100% Reduce/ Enlarge Quality Original A4 Register A4 25/10/'01 19:20 Job cancel Back Edge Orig. set direction Edit 2 Touch the "Document printing" key under "Shared Data Box". The "Document printing" screen will be displayed. Inch specifications Select function. Document Management 25/10/'01 19:20 End Synergy Print Box Form box NOTE Refer to "Entering characters" on page 7-75 for information on entering characters. Shared Data Box Document reg. Box Editing Document printing Document reg. Box Editing Document printing Form reg. Box Editing 5 Touch the "Select orig. size" ["Select size orig. "] key, the "Select regi. size" key, the "Original type" key, the "Reduce/ Enlarge" key and/or the "Orig. set direction" key, if you want to perform the corresponding settings. If you want to access the "Scanning density" key and/or the "Orig. image quality" ["Image quality"] key to make those settings, touch the "Quality" key. If you want to set access the "Border Erase" ["Erase Mode"] key and/or the "Continuous scanning" ["Multiple scanning"] key to make those settings, touch the "Edit" key. Metric specifications Select function. Document Management Shared Data Box Synergy Print Box Form box 25/10/'01 19:20 End Document registr. Box Editing Document printing Document registr. Box Editing Document printing Form registr. Box Editing 3 6 Press the [Start] key. Once all of the documents have been completely scanned, the touch panel will return to the screen in step 3. If you want to register another document, repeat steps 3 through 6. Select the documents to be printed out and then touch the "Finish selecting" key. Inch specifications Document printing Document data box Job 005 Job 004 Job 003 Job 002 1 1 1 1 1 Cancel Order of indication Conf/Crrt. details Up 25/10/01 25/10/01 25/10/01 25/10/01 25/10/01 001/010 Down 7 Touch the "End" key. The touch panel will return to the contents of the "Basic" tab. Job 001 Finish selecting Document Management - Shared Data Box Metric specifications Document printing Document data box JOB003 JOB002 JOB001 1 1 1 Job cancel Order of indication Check/Rev. [. . . ] Optical unit When checking the optical unit, avoid direct exposure to the laser beam, which is invisible. Shown at left is the label located on the cover of the optical unit. 4. Maintenance For safety of the service personnel, follow the maintenance instructions in the other section of this manual. 5. Safety switch The power to the laser unit is cut off when the front cover is opened. CAUTION! The power plug is the main isolation device! [. . . ]