User manual KYOCERA XI3648

[. . . ] Xi Repro System INSTRUCTION HANDBOOK ALWAYS read this Instruction Handbook thoroughly before use. After reading, maintain it in good condition and keep it together with the Instruction Handbook for your copier. Published in July '98 3AC80061 Revision 1 Preface Xi Repro System is designed to connect a large format digital copier to a computer to be used as a plotter controller system. This handbook describes how to use the software and applications included in Xi Repro System. Please refer to the instruction handbook of the large format digital copier for information about the installation and use of the copier. Notes · The contents of this handbook is subject to change without notice. [. . . ] · Files Displays the file to be printed. · Copies Used to set the number of copies. When checking "Collate", the set number of copies is printed page by page. When checking "Reverse", printing is performed from the last data in the sets/ members tree. · Media Displays the media, or paper, to be used. Use the Media tab in Properties to define the paper to be used (see 3. 13. 3 Media tab). 3-23 4. 4. 1 4. 2 4. 3 4. 4 4. 5 4. 6 4. 7 4. 8 Using Admin This section describes how to use Admin. Starting and closing the application Cost Center tab Report tab Scanner Sheet Size tab About Box Edit tab Device Data tab Printer tab Scanner tab Using Admin 4. Using Admin The Admin application allows device settings to be configured and system usage status reports to be viewed. There are seven tabs in the Administrator window. This chapter describes how to use each of these tabs. 4. 1 Starting and closing the application 4. 1. 1 Starting the application Perform the following steps to start the application. Click on "Start" in the task bar to open the start menu. Select "Programs" and then "Xi Repro System". The application starts and the Administrator window appears. 4-2 Using Admin 4. 1. 2 About the Administrator window This section describes the Administrator window which appears when the application starts. Used when closing the Admin application, changing the units system used in Admin or viewing Help. Displays information about the menu item indicated by the mouse. 4-3 Using Admin 4. 1. 3 Selecting the units system Perform the following steps to select the units system. Click on "Edit" in the menu bar to open the Edit menu. Select the units system to be used in "Measurements". 4-4 Using Admin 4. 1. 4 Closing the application Perform the following steps to close the application. Click on "File" in the menu bar to open the File menu. Click on "Exit". 4-5 Using Admin 4. 2 Cost Center tab The Cost Center tab displays a list of cost center information. This tab also allows cost centers to be added, edited or deleted. Cost centers are used to record the usage status of plotter/scanner devices. The cost center to be used for recording is specified from the Client application. Only the cost centers defined under the Cost Center tab will be available for selection in the Client application. 4-6 Using Admin 4. 2. 1 Adding a cost center To add a new cost center, click on the "Add" button. [. . . ] The patterns are defined in the patterns. dat file as 16 × 16 pixel blocks. The pattern file can be modified to add additional patterns. In general, patterns 0 through 15 are designed to be used for line work. Patterns 16 through 29 are designed for filled areas. [. . . ]