User manual KYOSHO AIRIUM CESSNA 182

[. . . ] 4GHz frequency is also used by other devices. microwave ovens , wireless LAN , Bluetooth , digital cordless phones operate on ISM bands and in an urban environment can influence the movement of the R/C system. Confirm the area is safe for operation and that your model responds properly to control inputs before beginning flying. [. . . ] Mode1 and Mode2 setting Before setting Mode1 and Mode2, turn airplane's power off. the switch for mode setting is in the battery cover. It cannot be used with large size or GP planes. Plug the ESC connector into throttle socket of the receiver and then connect the battery to the ESC. Press the binding button on the transmitter, then turn the transmitter power on. When the indicator light on the receiver light up, binding has been successfully completed. Unplug the short-circuit connector and the indicator light will light flashes. Press binding button again to return to the pre-existing condition. After the battery level indicator light flashes for a few seconds, it turns green to indicate the transmitter is operational. When the indicator light on the receiver lights up, the radio system is ready to be used. Avoid using materials that interfere with heat dissipation. Remove propeller or pinion gear, making sure nothing can contact the spinning parts of the motor and confirm there is no risk to other people. Fail Safe Protection Power will cut out if no signal comes from the receiver for more than 2 seconds. Motor Malfunction Prevention The throttle stick on the transmitter must be at its lowest position at the time the battery is connected for the motor to turn. [. . . ] Soft Cut : Gradually reduces output when battery voltage reaches set value Hard Cut : Cuts output immediately when battery voltage reaches set value Soft-Anlauf Wählbare Optionen: super soft / soft / normal | Werkseinstellung: soft supersoft: 1, 5 Sekunden bis Vollgas soft: 1, 0 Sekunden bis Vollgas normal: keine Verzögerung 7. Abschaltverhalten Wählbare Optionen: soft / hart | Werkseinstellung: soft soft: Die Motorleistung wird stufenweise reduziert, wenn die Abschaltspannung erreicht wird hart: Der Motor wird abgeschaltet, wenn die Abschaltspannung erreicht wird This product allows the setting of only one item at a time. For setting more than one item, after completing the first setting, remove the battery and then complete the setting of the next item. [. . . ]