User manual KYOSHO BLIZZARD DF-300

[. . . ] Cutting along curved lines never was so easy!1 Insert the AA-size dry batteries into the transmitter. 8 Make sure the servos move according to your transmitter inputs. Before assembling, please read the following carefully: Oe First, read this instruction manual and understand the modelÕs con-struction. [. . . ] Oe not take the wrong screw or small part. Compare it to the true-toDo scale dia- ram in each assembly step, then install it. Even if feeling hard, tighten a TP screw until the part will be securely attached. However, do not overtighten it as the plastic thread inside the part may strip!Before using them, check the screws on the true-to-scale diagrams on the left side in each assembly step. How to read the instruction manual: A: Indicates the number of the assembly step C: All parts except screws are identified by key numbers. For purchasing spare parts, find the key number of the part needed in the spare parts list and refer to the left column to look up the corresponding order number. d: This instruction manual uses several symbols. Please note them during the entire assembly at the bottom of each page. B Adjust the strength of brake (in other words, equalize the brake strength of both right and left) with 82 and 78 . Z In case of having too much tightnees in screwing, use a plier. Oe After running, be sure to disconnect Ni-Cad battery and remove it from your car. In case the 1st, 2nd gear and the backward gear don't work, it can be expected that 15W Resistor 45 is broken. Change it as shown on the drawing, paying a close attention to the wiring. WARNING: Do NOT operate the model in the following places and situations: (Non-observance may lead to accidents!Operate your model ONLY in spacious areas with no people around!In places where children and many people gather!* Non-observance may account for personal injury and property damage!With weak dry batteries, transmission and reception of the radio fall off. You may lose control of your model when operating it under such condition. This may also lead to serious accidents!Keep in mind that people around you may also operate a radio control model! [. . . ] NEVER share the same frequency with somebody else at the same time!Signals will be mixed and you will lose control of your model. Immediately stop the model and check the reason. as long as the problem is not cleared , do NOT operate it! [. . . ]