User manual KYOSHO CALIBER 3

[. . . ] Also, be very careful when handling glow fuel, as it is highly flammable and explosive! Oe Fuel should contain at least 15% of nitro metane. (Receiver) 7 Make sure the servos move according to Read through the manual before you begin, so you will have an overall idea of what to do. If you find any defective or missing parts, contact your local dealer or our Kyosho Distributor. [. . . ] This kit contains screws and hardware in different metric sizes and shapes. Before using them, check the screws on the true-to-scale diagrams on the left side in each assembly step. Self-tapping (TP) screws cut threads into the parts when being tightened. Excessive force may permanently damage parts when tightening TP screws. It is recommended to stop tightening when the part is attached or when some resistance is felt after the threaded portion enters the plastic. Before operating your helicopter, plug the crystal of your frequency into the Personal Fre-quency Monitor. As soon as you switch it on, you'll know for sure through an interfe-rence signal and LED lamps whether somebody else is on your fre-quency or not!L In Order to understand full assembly sequence, this instruction manual shows the complete assembly of this model, even though some elements are supplied pre-built. Please refer to it when carrying out maintenance or replacing parts. ^ó , ª , , é , Ù, ¤ , ª º Mark should be this way down B Be careful not for being bent. Note:Be sure to install 612 tightly against upper bearing. Do not operate the model again until the problem has been corrected. Because the use of gasoline and kerosene in R/C models ac-counts for fires, do NOT use them! Before flying, ensure all screws are tight!A single loose screw can cause accidents!Please do not fly high in the sky when fuel is less than 1/4 of fuel tank. It might cause to stop the engine because of bad circulation of fuel. NEVER use fuel indoors or in places with open fires and sources of heat!Store fuel ONLY in cool, dry and dark places out of children's reach!Never approach a fast turning rotor head!Stand at least 10m away from the rotor for injury prevention!Right after use, DO NOT touch the engine or muffler, as both generate a lot of heat. [. . . ] " , , ð , « , è Wipe off any dirt or oil deposits from your helicopter. WARNING: When replacing defective parts with new ones, please only use genuine Kyosho branded items. B Replace ball ends if they come off easily. Replace balls with the first sign of scratches or wear. [. . . ]