User manual KYOSHO CAP 232-60 BREITLING

[. . . ] If necessary, use a heat gun or iron to tighten the covering. ¬ , Ì S OE You can keep the covering film from wrinkling or peeling by spraying the plane with clear polyurethane. ` Symbols used throughout this instruction manual, comprise: @ not overlook this Do · Low setting Use an iron covered with a cloth! [. . . ] Being careful not to glue the fin and rudder together. Being careful to avoid getting glue in the hingepin areas. B , Make certain parts are aligned accurately and play is reduced to a minimum. B , - , é Attach gearpant and wheel to leg using parts provided making certain wheel rotates freely. B ` "\ , Make certain parts are alignedaccurately and play is reduced to a minimum. B , Make certain parts are aligned accurately and play is reduced to a minimum. Relive the cowl to clear the engine hed. @ Adjust the travel of each control surface to the values in the diagrams. For the correct placement of decals, please refer to box top. Oe This aircraft has been flight tested with snap-rolls and other aerobatic maneuvers. However, repeated violent maneuvers may overstress the airframe. Please fly in a way that will not otherstress the airframe. Oe Repeated flyng can cause stress cracks to appear in the wood and joints, please inspect after each flight. If any abnormalities are noted, repair immediately befor the next flight to avoid accsidents. [. . . ] Do not try to operate your model if this happens, but change your transmitter and receiver crystals to another frequency. B By moving the various transmitter controls, ensure that all control surfaces move the way you intend them to. Immediately disuse defective propellers as well as deformed spinners. [. . . ]