User manual KYOSHO CURTISS P-40 WARHAWK 40

[. . . ] Oe Always keep this instruction manual ready at hand for quick reference, even after completing the assembly. B Specifications are subject to change without prior notice!<ï CURTISS P-40 WARHAWK 40 is a radio control model, not a toy!B S In order to enjoy running the CURTISS P-40 WARHAWK 40, you need to finish assembly before operation. [. . . ] Furthermore, disconnect the batteries and remove them from the model and the transmitter. Store fuel only in cool, dry and dark places out of children's reach!Do not dispose of empty fuel cans into a fire!Do not put fingers or any objects inside rotating and moving parts!Right after use, do not touch the engine and muffler!I O , Í , With the use of an electric starter, you need a 7. 2V-1200mAh~3000mAh battery and a charger compatible with the battery in addition to what is required in the assembly instruction. B C N , ð This shows you remaining amount of the battery capacity with the Power Switch turned ON. B To control forward speed and reverse speed A. Make sure the Servo Reversing Switches are positioned as shown in the drawing below. Load 8 AA Alkaline Batteries as shown in the following illustration. After confirming that the carburetor is open about 1mm, fix the air cleaner. See if the clearances are the same as shown in the right side illustration, then connect the 7. If you make it run for over 5 seconds, the starter will generate heat or even set on fire. B , Fill the fuel tank, push the choke button to feed the fuel into the carburetor, then engage the starter. If the engine does not start, push the choke button once or twice. Once the engine starts, disengage the starter immediately. See if the engine runs faster by pushing the linkage (B) with a finger lightly. When the engine is in the starting process, the glow plug is heated automatically, you need not use any plug heater. B , If the starter does not rotate, stop the starting process promptly. B , ª , ª Despite the starter wiring unit and connector units are properly hooked up, still the starter will not drive the engine to start properly, you can think of the engine fed with excessive fuel. Eliminate the excessive fuel by driving the engine with the starter. [. . . ] Run the engine 2~3 tanks to complete the break-in. B I ^ , È The needle valve setting for normal engine running lies between 1 and 1/4 turns screwed out from closed position. Screwing it further in , excessive heat may be generated. B At this moment, do not tighten the needle valve any further. [. . . ]