User manual KYOSHO DMT

[. . . ] Contact our Customer Support Center for the latest information relating to product names and model numbers. The illustration of the screen and the recorder shown in this manual may differ from the actual product. The utmost care has been taken to ensure the integrity of this document but if you find a questionable item, error or omission, please contact our Customer Support Center. Any liability for passive damages or damage of any kind occurred due to data loss incurred by a defect of the product, repair performed by the third party other than Olympus or an Olympus authorized service station, or any other reason is excluded. [. . . ] pay attention to the following: · When used for a long period, the recorder will get hot. If you hold on to the recorder in this state, a low-temperature burn may be caused. In places subject to extremely cold temperatures, the temperature of the recorder's body may be lower than the environmental temperature. If possible, wear gloves when handling the recorder in cold temperatures. To prevent causing battery leaks or damaging their terminals, carefully follow all instructions regarding the use of batteries. Never attempt to disassemble a battery or modify it in any way, solder, etc. If a battery fluid gets into your eyes, flush your eyes immediately with clear, cold running water and seek medical attention immediately. f Warning: · Keep batteries dry at all times. Never subject batteries to strong shocks or continuous vibration. If a battery leaks, becomes discolored or deformed, or becomes abnormal in any other way during operation, stop using the recorder. If a battery leaks fluid onto your clothing or skin, remove the clothing and flush the affected area with clean, running cold water immediately. Delete any unnecessary file before recording. When the remaining recording time is less than 60 seconds, the recording indicator light starts flashing. When the recording time is decreasing to 30 or 10 seconds, the light flashes faster. Recording from external microphones or other devices: External microphones and other devices can be connected and the sound can be recorded. Do not plug and unplug devices into the recorder's jack while it is recording. The built-in microphone will become inoperable when an external microphone is plugged into the recorder's MIC jack. " · To avoid ear irritation, insert the earphone after turning down the volume level. When you listen with the earphone during playback, do not raise the volume too much. It may cause hearing impairment and a decrease in hearing ability. While the recorder is during playback mode, press and hold the 9 or 0 button. The recording indicator light will turn on. [. . . ] If an action is not selected within 8 seconds, the recorder will return to stop mode. It may take over 10 seconds to complete processing. Never remove batteries during this time because data may be corrupted. In addition, carefully check the remaining battery level in order to ensure that the battery will not run out while processing. [. . . ]