User manual KYOSHO DNX403 FERRARI 360 MODENA PARTS LIST

[. . . ] Every part has been carefully tested and subjected to KYOSHO AG's strict and continuous quality control. However, the service life of the device lies partially in your hands. For this reason, we ask you to read this manual carefully and to take note of the instructions contained herein. Thank you. 1. 2. 2 Trademarks All brands and trademarks mentioned in this document are possibly registered by third parties and are subject to the current legislation and to the rights of their respective owners without reservation. [. . . ] SAVE ROUTE: Opens a window in which a planned route can be saved under a particular name. i For detailed information, please refer to chapter "Saving a destination" on page 73. SHOW ON MAP: Shows the given address on the map. SETTINGS: Opens the SETTINGS window in which the navigation system can be configured. i For detailed information, please refer to chapter "Configuring P´ 9611" on page 85. i For detailed information, please refer to chapter "Saving a route" on page 75. SAVED ROUTES: Opens a window in which a saved route can be loaded. GPS STATUS: Opens the GPS STATUS window. Details regarding GPS reception can be viewed here and data regarding the current location can be stored. ROUTE PLANNING: Opens the ROUTE PLANNING window. Routes can be planned, edited and navigation for a planned route can be started from here. i i For detailed information, please refer to chapter "GPS status" on page 83. For detailed information, please refer to chapter "Planning routes" on page 74. HOME ADDRESS: Saves the selected destination as your home address which can then be started via the TAKE ME HOME button. CALIBRATION: Opens a window in which the touchscreen can be recalibrated, in the event that it becomes imprecise to the touch. ROUTE PROFILE: Opens the ROUTE PROFILE window in which the options for route calculation can be viewed and changed, if necessary. 76 ­77 07 Options 08 Working with the map SIMULATION: Simulates navigation based on the displayed route. Simulation can only be carried out for routes of max. GPS reception is not required for simulation. TRAFFIC: Opens the TRAFFIC INFORMATION window, in which pending reports can be listed. FACTORY SETTINGS: Opens a window in which all settings can be restored to their original factory settings. DELETE DESTINATION: Deletes the marked destination from the LAST DESTINATIONS or FAVORITES lists. The delete process must be confirmed by means of a dialog window. [ 2 ] Possible speed limits may be shown here. [ 3 ] If two maneuvers need to be executed quickly this shows the maneuver to be executed immediately after the next maneuver. [ 4 ] Shows a diagram of the next junction where you should turn off. Underneath is the remaining distance to this junction. [5] [6] [7] [8] [9] The nearer you are to the junction, the fewer green spots are displayed. If you don't have to change direction for a longer period, you will only see a forwardfacing arrow with the distance shown underneath, which shows how long you are to follow the current road. A triangle in GREEN shows the current position on the map. The displayed sector of the map changes continually to show your current position centered on the map whenever possible. The height above sea level and the current speed is shown here. Shows the route, the estimated trip duration, and the estimated time of arrival. Shows the entire route, the estimated trip duration and the estimated time of arrival for the current stage. [10 ] The traffic lanes that lead to your destination are depicted in the GREEN. [11 ] The name of the route section that you need to drive onto next is shown in the upper street field. [. . . ] [ 3 ] The user may create backup copies, restricted to absolutely necessary numbers, should it be necessary to do so due to reasons of data security or the retention of a quick reactivation of the computer system after a total failure of the scheduled backup of the total data storage, including the computer applications used. The relevant data carriers are to be designated as such. The backup copies may only be used for archive purposes. [ 4 ] Further reproductions, which also include release of the program code on a printer as well as photocopying of the manual, may not be made by the user. [. . . ]