User manual KYOSHO EDGE 540 VE29 SPARE PARTS

[. . . ] For painting the body, use Kyosho paints for models!CAUTION: Before using spray colors, always read their explanations!For safe masking jobs, use this plastic masking sheet featuring one self-adhesive edge. A new battery must be charged before it is used. [. . . ] All parts except screws are identified by key numbers. For purchasing spare parts, find the key no. Of the part needed in the spare part list and refer to the left column to look up the corresponding order no. This kit contains screws and hardware in different metric sizes and shapes. Before using them, check the screws on the true-to-scale diagrams on the left side in each assembly step. Self-tapping (TP) screws cut threads into the parts when being tightened. Excessive force may permanently damage parts when tightening TP screws. It is recommended to stop tightening when the part is attached or when some resistance is felt after the threaded portion enters the plastic. Attach the upper deck and make sure it doesn't twist or slip. 8 After applying Grease, place eight differential balls 118 between the two thrust washers 113 , grouping them around the screw 73 . If part 18 rotates into the opposite direction to part 17 , no further adjustment is necessary. Immediately stop the model and check the reason. as long as the problem is not cleared , do NOT operate it!This may lead to further trouble and unforeseen accidents! WARNING: in order to avoid accidents and personal injury, be sure to observe the following: Do NOT put fingers or any objects inside rotating and moving parts!Rotating / moving at high speed, you may be seriously injured! Before charging, please carefully read the explanations of the battery and charger unit!While charging, the battery and charger unit get hot!NEVER charge on top of or near easily inflammable material as this will result in fires!After operation, the electric motor and battery are hot!You may burn yourself seriously touching them!Ensure the cords do NOT trail into rotating and moving parts! [. . . ] Make sure the model steers according to your transmitter inputs. Make sure the speed (electric speed controller) changes according to your transmitter inputs. After finishing running, collect your car. CHECK When NOT using the model, always switch off the receiver and transmitter! [. . . ]